ST7MDT10-TEB/DVP STMicroelectronics, ST7MDT10-TEB/DVP Datasheet - Page 19

• Manufacturer Part Number: ST7MDT10-TEB/DVP
• Description: KIT ADAPTERS ST7
• Manufacturer: STMicroelectronics

Specifications of ST7MDT10-TEB/DVP

• Accessory Type: Target Board
• For Use With/related Products: ST7MDT10-DVP3 Emulator
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST7MDT10-DVP3 Probe User Guide
3.6
SO28 package
This procedure tells you how to connect the ST7MDT10-DVP3 to your application
board when your target ST7 microcontroller is in an SO28 package.
1 Solder the connection pins for the SO28 device adapter to your application
2 Ensure that the emulator and your application board are powered off.
3 Connect the 34-pin flat cable to the J1 connector on the ST7MDT10-DVP3
4 Plug the other end of the 34-pin flat cable into J1 on the SDIP32 adapter
board. When soldering, insert the two sets of connection pins into the device
adapter. The device adapter will serve as a support during soldering and will
ensure the correct spacing and alignment of the pins (see inset in
TEB, making certain to align the orientation guides as shown in
connect the 26-pin flat cable to the J2 connector, in the same manner.
(ref.: DB585), as shown in
SO28 device adapter
SDIP32 adapter with
Figure 10: SO28 connection to application board
Connection
pins
SO28 device
Figure 10
adapter
. Then plug the 26-pin flat cable into J2.
Connecting to your application board
Application board
Orientation
indicators
Figure 4
Figure 10
. Then
19/31
).