ST7MDT10-TEB/DVP STMicroelectronics, ST7MDT10-TEB/DVP Datasheet - Page 24

• Manufacturer Part Number: ST7MDT10-TEB/DVP
• Description: KIT ADAPTERS ST7
• Manufacturer: STMicroelectronics

Specifications of ST7MDT10-TEB/DVP

• Accessory Type: Target Board
• For Use With/related Products: ST7MDT10-DVP3 Emulator
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Emulation characteristics
4
4.1
MCU
F
WDG.HALT (Watchdog halt)
WDG.SW (Watchdog)
24/31
OSC
EMULATION CHARACTERISTICS
On-chip peripherals configuration
You can configure certain on-chip peripherals in ST7 Visual Develop’s MCU
Configuration dialog box so that the emulator accurately emulates your target
device.
The on-chip peripheral options available for configuration for the ST7MDT10-DVP3
emulator are described in this section.
The MCU Selection tab in STVD7’s Project Settings window allows you to select
from a list of MCU’s that are supported by the software. The STVD7 release notes
provide the most up to date list of supported microcontrollers for your emulator.
The clock frequency (F
There are two options: Reset or No Reset . If this option is set to Reset , when the
Watchdog is enabled and a Halt instruction is encountered in the executable code,
a chip reset will be performed. If this option is set to No Reset , no chip reset will be
performed.
This option allows you to choose whether the watchdog timer is enabled by
software or by hardware.
Refer to the datasheet of your target ST7 MCU for more information on the
watchdog timer.
Clock options
External
16 MHz
8 MHz
4 MHz
2 MHz
OSC
Table 4: Clock frequency options
) options are summarized in
Provided by user via the EXTCLK pin on connector
W3 of the ST7 DVP3 MEB (MB352)
Clock Source Location
On emulator
ST7MDT10-DVP3 Probe User Guide
Table 4
below.