ST7MDT10-TEB/DVP STMicroelectronics, ST7MDT10-TEB/DVP Datasheet - Page 9

• Manufacturer Part Number: ST7MDT10-TEB/DVP
• Description: KIT ADAPTERS ST7
• Manufacturer: STMicroelectronics

Specifications of ST7MDT10-TEB/DVP

• Accessory Type: Target Board
• For Use With/related Products: ST7MDT10-DVP3 Emulator
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST7MDT10-DVP3 Probe User Guide
3
CONNECTING TO YOUR APPLICATION BOARD
In addition to providing the firmware to emulate your MCU, the ST7MDT10-DVP3
emulator serves as the hardware interface between your host PC and your
application. Your DVP3 emulator comes with the connectors and adapters for a
specific package type. These accessories allow you to connect your emulator to
your application board in place of your ST7 microcontroller.
You can also install one or two HE10 type connectors (depending on the MCU you
wish to emulate) directly on your application board. Doing so will allow you to
connect the emulator to your application board without using adapters and
sockets/connectors.
This chapter provides information about connecting to your application board:
•
•
•
•
•
•
•
DVP3 Main
Emulation Board
Section 3.1
Section 3.2
Section 3.3
Section 3.4
Section 3.5
Section 3.6
Section 3.7
ST7MDT10-DVP3
Target Emulation Board
— for microcontrollers in a DIP16 package
— for microcontrollers in a SO16 package
— for microcontrollers in a DIP20 package
— for microcontrollers in a SO20 package
— for microcontrollers in a SDIP32 package
— for microcontrollers in a SO28 package
— with two HE10 connectors installed on the application board
Figure 3: DVP3 to application board connection
34 and 26-pin flat cables
Adapter connected
to MCU socket on
the application board
ST7MDT10-DVP3 emulator with
Connecting to your application board
SDIP32 device adapter
9/31