EVALA5970AD STMicroelectronics, EVALA5970AD Datasheet - Page 9

• Manufacturer Part Number: EVALA5970AD
• Description: BOARD EVAL FOR A5970AD REG
• Manufacturer: STMicroelectronics

Specifications of EVALA5970AD

• Main Purpose: DC/DC, Step Down
• Outputs And Type: 1, Non-Isolated
• Voltage - Output: 1.235 ~ 35V
• Current - Output: 1A
• Voltage - Input: 4 ~ 36V
• Regulator Topology: Buck
• Frequency - Switching: 500kHz
• Board Type: Fully Populated
• Utilized Ic / Part: A5970AD
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

A5970AD
5
5.1
Functional description
The main internal blocks are shown in the device block diagram in
●
●
●
●
●
●
●
●
●
Figure 3.
Power supply and voltage reference
The internal regulator circuit (shown in
voltage pre-regulator, the Bandgap voltage reference and the Bias block that provides
current to all the blocks. The Starter supplies the start-up currents to the entire device when
the input voltage goes high and the device is enabled (inhibit pin connected to ground). The
pre-regulator block supplies the Bandgap cell with a pre-regulated voltage V
very low supply voltage noise sensitivity.
A voltage regulator supplying the internal circuitry. From this regulator, a 3.3 V
reference voltage is externally available.
A voltage monitor circuit which checks the input and the internal voltages.
A fully integrated sawtooth oscillator with a frequency of 500 kHz ± 15%, including also
the voltage feed forward function and an input/output synchronization pin.
Two embedded current limitation circuits which control the current that flows through
the power switch. The pulse-by-pulse current limit forces the power switch OFF cycle
by cycle if the current reaches an internal threshold, while the frequency shifter reduces
the switching frequency in order to significantly reduce the duty cycle.
A transconductance error amplifier.
A pulse width modulator (PWM) comparator and the relative logic circuitry necessary to
drive the internal power.
A high side driver for the internal P-MOS switch.
An inhibit block for stand-by operation.
A circuit to implement the thermal protection function.
Block diagram
Doc ID 14661 Rev 4
Figure
4) consists of a start-up circuit, an internal
Figure
Functional description
3. They are:
REG
that has a
9/42