AT89C51CC02UA-RATUM Atmel, AT89C51CC02UA-RATUM Datasheet - Page 41

• Manufacturer Part Number: AT89C51CC02UA-RATUM
• Description: IC 8051 MCU 16K FLASH 32-VQFP
• Manufacturer: Atmel
• Series: AT89C CANr

Specifications of AT89C51CC02UA-RATUM

• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 40MHz
• Connectivity: CAN, UART/USART
• Peripherals: POR, PWM, WDT
• Number Of I /o: 20
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 32-TQFP, 32-VQFP
• Processor Series: AT89x
• Core: 8051
• Data Bus Width: 8 bit
• Data Ram Size: 512 B
• Interface Type: UART
• Maximum Clock Frequency: 40 MHz
• Number Of Programmable I/os: 20
• Number Of Timers: 1
• Operating Supply Voltage: 3 V to 5.5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: PK51, CA51, A51, ULINK2
• Development Tools By Supplier: CANADAPT28
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 8 Channel
• For Use With: AT89OCD-01 - USB EMULATOR FOR AT8XC51 MCU
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Flash Protection from Parallel
Programming
Preventing Flash Corruption
4126L–CAN–01/08
Figure 17. Reading Procedure
Note:
The three lock bits in Hardware Security Byte (See ’In-System Programming’ section)
are programmed according to Table 24 provide different level of protection for the on-
chip code and data located in FM0 and FM1.
The only way to write this bits are the parallel mode. They are set by default to level 3.
Table 24. Program Lock bit
Note:
WARNING: Security level 2, 3 and 4 should only be programmed after Flash and Core
verification.
See Section “Power Management”.
Security
Level
1
2
3
4
Program Lock bits
aa = 10 for the Hardware Security Byte.
1. Program Lock bits
U: unprogrammed
P: programmed
LB0
U
P
U
U
LB1
U
U
P
U
LB2
U
U
U
P
Protection Description
No program lock features enabled.
Parallel programming of the Flash is disabled.
Same as 2, also verify through parallel programming interface is
disabled. This is the factory defaul programming.
Same as 3
Exec: MOVC A, @A+DPTR
Flash Spaces Reading
Flash Spaces Mapping
FCON = 00000aa0b
DPTR = Address
FCON = 00h
Clear Mode
Data Read
ACC= 0
AT/T89C51CC02
41