MC912DG128AMPVE Freescale Semiconductor, MC912DG128AMPVE Datasheet - Page 171

• Manufacturer Part Number: MC912DG128AMPVE
• Description: IC MCU 128K FLASH 8MHZ 112-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC12r

Specifications of MC912DG128AMPVE

• Core Processor: CPU12
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: CAN, I²C, SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x8/10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 112-LQFP
• Processor Series: HC912D
• Core: HC12
• Data Bus Width: 16 bit
• Data Ram Size: 8 KB
• Interface Type: CAN/I2C/SCI/SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 69
• Number Of Timers: 8
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: EWHCS12
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 2 (8-ch x 10-bit)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

12.6.8 Pseudo-STOP
MC68HC912DT128A — Rev 4.0
MOTOROLA
Each time the 13-stage counter reaches a count of 4096 XCLK cycles
(every 8192 cycles), a check of the clock monitor status is performed. If
the clock monitor indicates the presence of an external clock limp-home
mode is de-asserted, the LHOME flag is cleared and the limp-home
interrupt flag is set. Upon leaving limp-home mode, BCSP and MCS are
restored to their values before the loss of clock, and all clocks return to
their previous frequencies. If AUTO and BCSP were set before the clock
loss, the SYSCLK ramps-up and the PLL locks at the previously selected
frequency.
To prevent PLL operation when the external clock frequency comes
back, the software should clear the BCSP bit while running in limp-home
mode.
When using an external clock, i.e. a square wave source, it is possible
to exit STOP with the DLY bit cleared. In this case the LHOME flag is
never set and STOP is de-asserted without delay.
Pseudo-STOP is a low power mode similar to STOP where the external
oscillator is allowed to run (at reduced amplitude) whilst the rest of the
part is in STOP. This increases the current consumption over STOP
mode by the amount of current in the oscillator, but reduces wear and
mechanical stress on the crystal.
If the PSTP bit in the PLLCR register is set, the MCU goes into Pseudo-
STOP mode when a STOP instruction is executed.
Pseudo-STOP mode is exited the same as STOP with an external reset,
an external interrupt from IRQ or XIRQ, a Key Wake-Up interrupt from
port J or port H, or an MSCAN Wake-Up interrupt.
The effect of the DLY bit is the same as noted above in
Fast STOP
Freescale Semiconductor, Inc.
For More Information On This Product,
Recovery.
Go to: www.freescale.com
Clock Functions
Limp-Home and Fast STOP Recovery modes
STOP Exit and
Clock Functions
Technical Data
171