MC912DG128AMPVE Freescale Semiconductor, MC912DG128AMPVE Datasheet - Page 178

• Manufacturer Part Number: MC912DG128AMPVE
• Description: IC MCU 128K FLASH 8MHZ 112-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC12r

Specifications of MC912DG128AMPVE

• Core Processor: CPU12
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: CAN, I²C, SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x8/10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 112-LQFP
• Processor Series: HC912D
• Core: HC12
• Data Bus Width: 16 bit
• Data Ram Size: 8 KB
• Interface Type: CAN/I2C/SCI/SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 69
• Number Of Timers: 8
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: EWHCS12
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 2 (8-ch x 10-bit)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Clock Functions
Technical Data
178
ACQ — Not in Acquisition
PSTP — Pseudo-STOP Enable
LHIE — Limp-Home Interrupt Enable
NOLHM —No Limp-Home Mode
If AUTO = 1 (ACQ is Read Only)
If AUTO = 0
In Pseudo-STOP mode, the oscillator is still running while the MCU is
maintained in STOP mode. This allows for a faster STOP recovery
and reduces the mechanical stress and aging of the resonator in case
frequent STOP conditions at the expense of a slightly increased
power consumption.
Forced to 0 when VDDPLL is at VSS level.
Read anytime; Normal modes: write once; Special modes: write
anytime. Forced to 1 when VDDPLL is at VSS level.
Freescale Semiconductor, Inc.
For More Information On This Product,
0 = PLL VCO is not within the desired tolerance of the target
1 = After the phase lock loop circuit is turned on, indicates the PLL
0 = High bandwidth PLL loop selected
1 = Low bandwidth PLL loop selected
0 = Pseudo-STOP oscillator mode is disabled
1 = Pseudo-STOP oscillator mode is enabled
0 = Limp-Home interrupt is disabled
1 = Limp-Home interrupt is enabled
0 = Loss of reference clock forces the MCU in limp-home mode.
1 = Loss of reference clock causes standard Clock Monitor reset.
frequency. The loop filter is in high bandwidth, acquisition
mode.
VCO is within the desired tolerance of the target frequency.
The loop filter is in low bandwidth, tracking mode.
Go to: www.freescale.com
Clock Functions
MC68HC912DT128A — Rev 4.0
MOTOROLA