MC912D60CCPVE Freescale Semiconductor, MC912D60CCPVE Datasheet - Page 273

• Manufacturer Part Number: MC912D60CCPVE
• Description: IC MCU 16BIT 112-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC12r

Specifications of MC912D60CCPVE

• Core Processor: CPU12
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: CAN, MI Bus, SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 68
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 1K x 8
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x8/10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 112-LQFP
• Processor Series: HC912D
• Core: HC12
• Data Bus Width: 16 bit
• Data Ram Size: 2 KB
• Interface Type: CAN, SCI, SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 86
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: EWHCS12
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 8 Channel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

MC68HC912D60A — Rev. 3.1
Freescale Semiconductor
RDRF — Receive Data Register Full Flag
IDLE — Idle Line Detected Flag
OR — Overrun Error Flag
NF — Noise Error Flag
FE — Framing Error Flag
Once cleared, IDLE is not set again until the RxD line has been active
and becomes idle again. RDRF is set if a received character is ready
to be read from SCxDR. Clear the RDRF flag by reading SCxSR1 with
RDRF set and then reading SCxDR.
Receiver idle line is detected (the receipt of a minimum of 10/11
consecutive ones). This bit will not be set by the idle line condition
when the RWU bit is set. Once cleared, IDLE will not be set again until
after RDRF has been set (after the line has been active and becomes
idle again).
New byte is ready to be transferred from the receive shift register to
the receive data register and the receive data register is already full
(RDRF bit is set). Data transfer is inhibited until this bit is cleared.
Set during the same cycle as the RDRF bit but not set in the case of
an overrun (OR).
Set when a zero is detected where a stop bit was expected. Clear the
FE flag by reading SCxSR1 with FE set and then reading SCxDR.
0 = SCxDR empty
1 = SCxDR full
0 = RxD line is idle
1 = RxD line is active
0 = No overrun
1 = Overrun detected
0 = Unanimous decision
1 = Noise on a valid start bit, any of the data bits, or on the stop bit
0 = Stop bit detected
1 = Zero detected rather than a stop bit
Multiple Serial Interface
Serial Communication Interface (SCI)
Multiple Serial Interface
Technical Data
273