DS72011RB120FPV Renesas Electronics America, DS72011RB120FPV Datasheet - Page 1056

• Manufacturer Part Number: DS72011RB120FPV
• Description: IC SH7201 MPU ROMLESS 176LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7200r

Specifications of DS72011RB120FPV

• Core Size: 32-Bit
• Core Processor: SH-2A
• Speed: 120MHz
• Connectivity: CAN, EBI/EMI, FIFO, I²C, SCI, Serial Sound
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 104
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 70°C
• Package / Case: 176-LQFP
• No. Of I/o's: 109
• Ram Memory Size: 32KB
• Cpu Speed: 120MHz
• Digital Ic Case Style: LQFP
• Supply Voltage Range: 3V To 3.6V
• Operating Temperature Range: -20°C To +70°C
• Embedded Interface Type: I2C, SSI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: R0K572011S000BE - KIT STARTER FOR SH7201HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)
• Eeprom Size: -
• Program Memory Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Section 27 Advanced User Debugger II (AUD-II)
(1) Description of Pins
Table 27.2 Description of Pins
Page 1028 of 1190
Pin
AUDMD
AUDRST
AUDCK
AUDSYNC
AUDATA[3:0]
Function
The mode is selected by changing the input level at this pin.
Low: Setting prohibited
High: RAM monitor mode
The input at this pin should be changed when AUDRST is low.
When this pin is driven low, the AUD enters the reset state and the AUD's
internal buffers and logic are reset. When AUDRST goes high again after the
AUDMD level settles, the AUD starts operating in the selected mode.
Note that the available frequency is up to Bφ/2.
AUD Bus Command Valid Signal
1: Read data is output
0: Inputs write address, data, DIR command
•
•
•
When a command is input from outside, data is output after Ready is
transmitted. The output starts after AUDSYNC is negated. For details, see the
protocol as described later.
This pin is for external clock input. Input the clock to be used for debugging.
The following data is output in time-sharing mode.
Note: Do not assert this pin until commands are input to AUDATA from
AUD bus command
Address
Data
outside and necessary data is prepared. For details, see the protocol
as described later.
R01UH0026EJ0300 Rev. 3.00
SH7201 Group
Sep 24, 2010