HD6417751RF240V Renesas Electronics America, HD6417751RF240V Datasheet - Page 412

• Manufacturer Part Number: HD6417751RF240V
• Description: MPU 1.5/3.3V 0K PB-FREE 256-QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7750r

Specifications of HD6417751RF240V

• Core Processor: SH-4
• Core Size: 32-Bit
• Speed: 240MHz
• Connectivity: EBI/EMI, FIFO, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 39
• Program Memory Type: ROMless
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 256-QFP Exposed Pad, 256-eQFP, 256-HQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

11. Realtime Clock (RTC)
11.3 (a), and the procedure using carry interrupts in figure 11.3 (b). The method without using
interrupts is normally used to keep the program simple.
11.3.3
The use of the alarm function is illustrated in figure 11.4.
An alarm can be generated by the second, minute, hour, day-of-week, day, month, or year
(SH7751R only) value, or a combination of these. Write 1 to the ENB bit in the alarm registers
involved in the alarm setting, and set the alarm time in the lower bits. Write 0 to the ENB bit in
registers not involved in the alarm setting.
When the counter and the alarm time match, RCR1.AF is set to 1. Alarm detection can be
confirmed by reading this bit, but normally an interrupt is used. If 1 has been written to
RCR1.AIE, an alarm interrupt is generated in the event of alarm, enabling the alarm to be
detected.
The alarm flag remains set while the counter and alarm time match. If the alarm flag is cleared by
writing 0 during this period, it will therefore be set again immediately afterward. This needs to be
taken into consideration when writing the program.
Rev.4.00 Oct. 10, 2008 Page 312 of 1122
REJ09B0370-0400
Alarm Function
(Wait for interrupt or check
Disable alarm interrupts
Enable alarm interrupts
Monitor alarm time
Clear alarm flag
Set alarm time
Clock running
alarm flag)
Figure 11.4 Example of Use of Alarm Function
Clear RCR1.AIE to prevent erroneous interrupts
Be sure to reset the flag as it may have been
set during alarm time setting
Set RCR1.AIE to 1