MC908AZ32ACFU Freescale Semiconductor, MC908AZ32ACFU Datasheet - Page 150

• Manufacturer Part Number: MC908AZ32ACFU
• Description: IC MCU 32K FLASH 8.4MHZ 64-QFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC908AZ32ACFU

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: CAN, SCI, SPI
• Peripherals: LVD, POR, PWM
• Number Of I /o: 40
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 512 x 8
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 15x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Serial Communications Interface (SCI)
To verify a stop bit and to detect noise, recovery logic takes samples at RT8, RT9, and RT10.
summarizes the results of the stop bit samples.
16.4.3.4 Framing Errors
If the data recovery logic does not detect a logic 1 where the stop bit should be in an incoming character,
it sets the framing error bit, FE, in SCS1. A break character also sets the FE bit because a break character
has no stop bit. The FE bit is set at the same time that the SCRF bit is set.
16.4.3.5 Baud Rate Tolerance
A transmitting device may be operating at a baud rate below or above the receiver baud rate.
Accumulated bit time misalignment can cause one of the three stop bit data samples to fall outside the
actual stop bit. Then a noise error occurs. If more than one of the samples is outside the stop bit, a framing
error occurs. In most applications, the baud rate tolerance is much more than the degree of misalignment
that is likely to occur.
As the receiver samples an incoming character, it resynchronizes the RT clock on any valid falling edge
within the character. Resynchronization within characters corrects misalignments between transmitter bit
times and receiver bit times.
Slow Data Tolerance
150
Figure 16-9
error or a framing error. The slow stop bit begins at RT8 instead of RT1 but arrives in time for the stop
bit data samples at RT8, RT9, and RT10.
shows how much a slow received character can be misaligned without causing a noise
RECEIVER
RT CLOCK
RT8, RT9, and RT10 Samples
000
001
010
011
100
101
110
111
MC68HC908AZ32A Data Sheet, Rev. 2
Table 16-7. Stop Bit Recovery
MSB
Figure 16-9. Slow Data
Framing Error Flag
SAMPLES
DATA
1
1
1
0
1
0
0
0
STOP
Noise Flag
0
1
1
1
1
1
1
0
Freescale Semiconductor
Table 16-7