A24-HASM-450 Digi International/Maxstream, A24-HASM-450 Datasheet - Page 17
![no-image](/images/no-image-200.jpg)
A24-HASM-450
Manufacturer Part Number
A24-HASM-450
Description
ANT 2.4GHZ DIPOLE HALF-WAVE
Manufacturer
Digi International/Maxstream
Series
XPressr
Specifications of A24-HASM-450
Antenna Type
Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
Number Of Bands
1
Frequency
2.4GHz
Vswr
2
Gain
2.1dBi
Termination
RP-SMA
Mounting Type
Connector
Height (max)
4.35" (110.5mm)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
70000340
Q2724499B
Q2724499B
XBee/XBee‐PRO OEM RF Modules ‐ ZigBee ‐ v1.x1x [2007.06.01]
3.2. ZigBee Network Communications
3.2.1. ZigBee Device Addressing
3.2.2. ZigBee Application-layer Addressing
16-bit Network Addresses
64-bit Addresses
Zigbee supports device addressing and application layer addressing. Device addressing specifies
the destination address of the device a packet is destined to. Application layer addressing indicates
a particular application recipient, known as a Zigbee endpoint, along with message type fields
called cluster IDs.
The 802.15.4 protocol upon which the ZigBee protocol is built specifies two address types:
A 16-bit Network Address is assigned to a node when the node joins a network. The Network
Address is unique to each node in the network. However, Network Addresses are not static - it can
change.
The following two conditions will cause a node to receive a new Network Address:
ZigBee requires that data be sent to the 16-bit network address of the destination device. This
requires that the 16-bit address be discovered before transmitting data. See 3.2.3 Network
Address Discovery for more information.
Each node contains a unique 64-bit address. The 64-bit address uniquely identifies a node and is
permanent.
The ZigBee application layers define endpoints and cluster identifiers (cluster IDs) that are used to
address individual services or applications on a device. An endpoint is a distinct task or application
that runs on a ZigBee device, similar to a TCP port. Each ZigBee device may support one or more
endpoints. Cluster IDs define a particular function or action on a device. Cluster IDs in the ZigBee
home controls lighting profile, for example, would include actions such as “TurnLightOn”,
“TurnLightOff”, “DimLight”, etc.
Suppose a single radio controls a light dimmer and one or more light switches. The dimmer and
switches could be assigned to different endpoint values. To send a message to the dimmer, a
remote radio would transmit a message to the dimmer endpoint on the radio. In this example, the
radio might support cluster IDs to “TurnLightOn”, “TurnLightOff”, or “DimLight”. Thus, for radio A to
turn off a light on radio B, radio A would send a transmission to the light switch endpoint on radio
B, using cluster ID “TurnLightOff”. This is shown in the figure below.
1.
2.
© 2007 Digi International, Inc.
• 16-bit Network Addresses
• 64-bit Addresses
If an end device cannot communicate with its parent it may need to leave the network and
rejoin to find a new parent.
If the device type changes from router to end device, or vice-versa, the device will leave
the network and rejoin as the new device type.
Chapter 3 ‐ ZigBee Networks
17