A11215RNCQ C&K Components, A11215RNCQ Datasheet - Page 3

• Manufacturer Part Number: A11215RNCQ
• Description: SWITCH ROTARY SP 12POS PC MNT
• Manufacturer: C&K Components
• Series: Ar
• Type: Rotary Switchr

Specifications of A11215RNCQ

• Number Of Positions: 12
• Number Of Decks: 1
• Number Of Poles Per Deck: 1
• Circuit Per Deck: SP12T
• Contact Rating @ Voltage: 2.5A @ 125VAC
• Actuator Type: Flatted (6.35mm dia)
• Mounting Type: Panel, PCB Through Hole
• Termination Style: PC Pin
• Orientation: Vertical
• Angle Of Throw: 30°
• No. Of Poles: 1
• No. Of Switch Positions: 12
• Contact Current Ac Max: 2.5A
• Contact Current Dc Max: 350mA
• Contact Voltage Ac Max: 125V
• Contact Voltage Dc Max: 125V
• Circuitry: SP12T
• Total # Of Positions: 12
• Pole Throw Configuration: SP
• Actuator Style: Shaft
• Actuator Material: Glass/Nylon 6/6
• Current Rating (max): 2.5A
• Illumination Type: Not Required
• Ac Voltage Rating (max): 125VVAC
• Dc Voltage Rating (max): 125VVDC
• Contact Material: Coin Silver
• Contact Plating: Silver
• Product Height (mm): 60.59mm
• Product Depth (mm): 26.19mm
• Product Length (mm): 26.19mm
• Operating Temp Range: -30C to 85C
• Terminal Type: PC Pins
• Index Angle: 30 deg
• Contact Style: Non Shorting
• Dielectric Strength: 1000 Vrms
• Voltage Rating: 125 Volts
• Current Rating: 2.5 A
• Actuator: (STD.) 1.500" high, flatted
• Voltage Rating Ac: 125 Volts
• Voltage Rating Dc: 125 Volts
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Compliant, Lead free / RoHS Compliant
• Other names: *A11215RNCQ; CKC7001

15
R
N
S
1.500" HIGH
SHORTING CONTACTS (make-before-break)
3/8-32 THREAD
NON-SHORTING CONTACTS (break-before-make)
PANEL MOUNTING
3
/
8
IN. BUSHING
SHORTING/NON-SHORTING CONTACTS
03
.375" HIGH
NOTE: ‘S’ shorting contacts are not available with A114, A124 and A214 models.
MOUNTING STYLE
ACTUATOR
NOTE: Actuators shown in position 1, fully CCW.
M
05
M10 x .75 METRIC
.500" HIGH
PANEL MOUNTING
METRIC BUSHING
K–5
14
1.500" HIGH
1-4 Pole Rotary Switches
not exceed 10 in./lbs.
push on knob should
42
Maximum force to
Install switch with stop ring (if used) and
lockwasher in back of panel. Tighten hex nut
from front of panel.
On PC mounted switches, use hex nut and
lockwasher to hold stop ring in place.
Actuation torque: 8–16 oz./in.
Maximum torque: 30 oz./in.
1.654" METRIC
Specifications and dimensions subject to change
TYPICAL INSTALLATION
www.ck-components.com
S1
Dimensions are shown: mm
A Series
SCREWDRIVER SLOT
NUT
LOCKWASHER
K