CS1WCN626 Omron, CS1WCN626 Datasheet - Page 99

• Manufacturer Part Number: CS1WCN626
• Description: Controllers CABLE PROG Dsub9
• Manufacturer: Omron
• Series: CS1Wr

Specifications of CS1WCN626

• Product: D-Sub Assemblies
• Connector End A: USB Type A Plug
• Connector End B: D-Sub 9P Female
• Length: 6 m
• Cable Type: Connection Cable
• Current Rating: 35 mA
• Description/function: Connects DOS computer
• Equipment Type: Connector Cable
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Two- and four-channel high-speed counter
units with built-in fast control I/O
• Max. input frequency = 500 kHz. (when line driver
• Output turns ON less than 0.5 ms after set value
• 32-bit counting range.
• 2- and 4-axis operation available.
• Digital variable noise filter provided.
• 5-, 12-, and 24-V line driver inputs available. (5- and
• Supports simple, ring, and linear counting modes.
• Supports offset phase input, up and down pulse
• Supports 4 external control inputs, and a total of 16
• One Unit supports 4 external outputs and 28 internal
• Pulse rate measurement function and data logging.
• Counter outputs and external control inputs can be
• Settings can be changed during Unit operation.
The High-speed Counter Units count pulse signal inputs that are too
fast to be detected by normal Input Units. The Units can be program-
med to produce outputs according to counter values for specified con-
ditions, and many other functions are supported.
High-speed Counter Units
Function
System Configuration
CS1W-CT0@1, C200H-CT021
High-speed Counter Units
input is used)
is reached. (may deviate during execution of IORD/
IOWR instructions)
12-V line driver input is only available, however, for
1 axis with the CS1W-CT021 and 2 axes with the
CS1W-CT041.)
input, and pulse+direction input.
functions can be set including open gate, close gate,
preset, reset, capture, stop/capture/reset combina-
tions, and reset enable.
outputs with counter value zone comparisons, target
comparisons, delays, holds, programmable outputs,
and hysteresis settings.
used to trigger interrupt tasks in the CPU Unit.
Counter inputs
Encoder
345