IC-WKM SO8-TP LASER COMPONENTS, IC-WKM SO8-TP Datasheet - Page 7

• Manufacturer Part Number: IC-WKM SO8-TP
• Description: IC, DRIVER LASER DIODE, SOIC8, WKM
• Manufacturer: LASER COMPONENTS

Specifications of IC-WKM SO8-TP

• Laser Driver Type: Laser Diode
• Supply Current: 350mA
• Supply Voltage Range: 3.6V To 15V
• Driver Case Style: SOIC
• No. Of Pins: 8
• Operating Temperature Max: 85°C
• Operating Temperature Min: -40°C
• Base Number: 08
• Device Type: LED
• Ic Generic Number: WKM
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Laser light can damage the human eye and the
eyes of animals! Do not look at any laser light di-
rectly or through any optical lens. When handling a
laser diode, do not look directly at the light generated
by it. Wear appropriate safety glasses to prevent light
from entering the eye even by reflection.
Setting the output power
The output power is simply set by RM = V(MDA) /
I(MD); with V(MDA) = Item-No. 101 and I(MD) = mon-
itor current of the laser diode at the desired operat-
ing point. RM should be combined from fixed resistor
(max. output power) and a trimmer (calibration).
Turn-on behaviour
After switching the supply voltage on, the output stage
remains disabled until the internal enabling flip-flop is
set by a sufficiently high voltage at VCC.
A quick soft start follows; the transition to controlled
CW operation is gradual and primarily determined by
the values of CI and RM. CI is properly dimensioned
when the voltage overshoot at MDA is at a minimum.
Turn-off behaviour
iC-WKM works without a fixed undervoltage lockout,
thus the laser diode forward voltage is the prime factor
determining the lowest possible supply voltage.
SAFETY INSTRUCTIONS
FUNCTION DESCRIPTION
iC-WKM
M-TYPE CW LASER DIODE DRIVER
−100mV
V(LDA)
V(MDA)
200mV
100mV
500mV
200mA
100mA
I(LD)
V(CI)
1,5V
1,0V
2V
1V
0
0
0
0
0
Figure 1: Turn-on behaviour
50us
100us
Time
150us
200us
250us
If the voltage drops below this value, the output stage
is forcibly saturated and the laser current decreases.
iC-WKM simultaneously discharges the control capac-
itor CI so that no excessive laser diode currents occur
when the supply voltage rises again.
Disruptions in operation
The power control is shut down with excessive driver
temperature or when the laser current reaches the
overcurrent shutdown threshold, for example when the
feedback is interrupted. If the monitor diode or the bias
resistor RM fail, the device is shut down in less than
600 µs, provided that the supply voltage applied is high
enough.
When modulating the laser current via pin MDK, ex-
cessive voltage occurring at pin MDA also may cause
a shutdown.
−100mV
V(MDA)
V(LDA)
200mV
100mV
500mV
200mA
100mA
I(LD)
1,5V
1,0V
V(CI)
2V
1V
0
0
0
0
Figure 2: Turn-off behaviour
1000us
Time
1,01ms
Rev C1, Page 7/9
1,02ms