DS8005-KIT# Maxim Integrated Products, DS8005-KIT# Datasheet - Page 8
![no-image](/images/manufacturer_photos/0/4/417/maxim_integrated_products_sml.jpg)
DS8005-KIT#
Manufacturer Part Number
DS8005-KIT#
Description
Power Management Modules & Development Tools DS8005 EVAL KIT DS8005 EVAL KIT
Manufacturer
Maxim Integrated Products
Datasheet
1.DS8005-RRX.pdf
(20 pages)
Specifications of DS8005-KIT#
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Smart Card Interface
8
24, 25
_______________________________________________________________________________________
PIN
12
13
15
16
17
18
19
20
21
22
23
26
27
28
CMDVCC
SEL_AB
XTAL1,
PRESB
NAME
XTAL2
V
RSTIN
CLKA
RSTA
V
I/OIN
OFF2
GND
I/OB
OFF
V
DDA2
CCA
DD
Smart Card Data-Line Output, Interface B. Card data communication line, contact C7. This pin is
only active if the second card interface is selected (SEL_AB high) and the interface has gone
through an activation sequence.
Interface B Card Presence Indicator. Active-high card presence input for the second card interface.
When the presence indicator becomes active, a debounce timeout begins. After 8ms (typ), the OFF
signal becomes active if the second card interface is selected (SEL_AB high), else the OFF2 signal
becomes active.
Smart Card Clock, Interface A. Card clock, contact C3.
Smart Card Reset, Interface A. Card reset output from contact C2.
Smart Card Supply Voltage, Interface A. Decouple to CGND (card ground) with 2 x 100nF or 100 +
220nF capacitors (ESR < 100m ).
Smart Card Interface Supply. 5V power supply for powering the card interface. While this pin is not
required to be connected to 5V (it can be left not connected (N.C.)), it is recommended for the best
performance when delivering power to a 5V smart card.
Activation Sequence Initiate. Active-low input from host.
Card Reset Input. Reset input from the host.
Supply Voltage
Digital Ground
Status Output for Selected Interface. Active-low interrupt output to the host. Includes a 20k
integrated pullup resistor to V
selected interface only (behaving as if it were a DS8024 with only one interface). The OFF2 pin
should be used to monitor presence events on the nonselected interface.
Crystal/Clock Input. Connect an input from an external clock to XTAL1 or connect a crystal across
XTAL1 and XTAL2.
I/O Input. Host-to-interface chip data I/O line.
Status Output for Nonselected Interface. This pin passes through the presence signal for the
nonselected interface. If SEL_AB is low (the A interface is selected), this pin reflects the state of the
PRESB input. If SEL_AB is high (the B interface is selected), this pin reflects the state of the PRESA
input.
Interface Selection. This pin selects the interface the input pins (I/OIN, RSTIN, etc.) communicate
with and control. If SEL_AB is low, the A interface is selected. Activation sequences power up V
and communication occurs with CLKA, I/OA, and RSTA. If SEL_AB is high, the B interface is
selected. Both interfaces can be powered and clocking at the same time. See the Switching A/B
Interfaces section for more information.
DD
. This pin reflects fault events and PRES_ events on the currently
FUNCTION
Pin Description (continued)
CCA