ADE7758ARWZRL Analog Devices Inc, ADE7758ARWZRL Datasheet - Page 67
![no-image](/images/manufacturer_photos/0/0/57/analog_devices_inc_sml.jpg)
ADE7758ARWZRL
Manufacturer Part Number
ADE7758ARWZRL
Description
IC,Power Metering,SOP,24PIN,PLASTIC
Manufacturer
Analog Devices Inc
Datasheet
1.ADE7758ARWZ.pdf
(72 pages)
Specifications of ADE7758ARWZRL
Input Impedance
380 KOhm
Measurement Error
0.1%
Voltage - I/o High
2.4V
Voltage - I/o Low
0.8V
Current - Supply
8mA
Voltage - Supply
4.75 V ~ 5.25 V
Operating Temperature
-40°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
24-SOIC (0.300", 7.50mm Width)
Meter Type
3 Phase
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ADE7758ARWZRL
Manufacturer:
ADI/亚德诺
Quantity:
20 000
LINE CYCLE ACCUMULATION MODE REGISTER (0x17)
The functionalities involved the line-cycle accumulation mode in the ADE7758 are defined by writing to the LCYCMODE register.
Table 22 summarizes the functionality of each bit in the LCYCMODE register.
Table 22. LCYCMODE Register
Bit
Location
0
1
2
3 to 5
6
7
Bit
Mnemonic
LWATT
LVAR
LVA
ZXSEL
RSTREAD
FREQSEL
Default
Value
0
0
0
7
1
0
Description
Setting this bit places the watt-hour accumulation registers (AWATTHR, BWATTHR, and CWATTHR
registers) into line-cycle accumulation mode.
Setting this bit places the VAR-hour accumulation registers (AVARHR, BVARHR, and CVARHR registers)
into line-cycle accumulation mode.
Setting this bit places the VA-hour accumulation registers (AVAHR, BVAHR, and CVAHR registers) into
line-cycle accumulation mode.
These bits select the phases used for counting the number of zero crossings in the line-cycle
accumulation mode. Bit 3, Bit 4, and Bit 5 select Phase A, Phase B, and Phase C, respectively. More than
one phase can be selected for the zero-crossing detection, and the accumulation time is shortened
accordingly.
Setting this bit enables the read-with-reset for all the WATTHR, VARHR, and VAHR registers for all three
phases, that is, a read to those registers resets the registers to 0 after the content of the registers have
been read. This bit should be set to Logic 0 when the LWATT, LVAR, or LVA bits are set to Logic 1.
Setting this bit causes the FREQ (0x10) register to display the period, instead of the frequency of the
line input.
Rev. D | Page 67 of 72
ADE7758