AT-GM-13A BANNER ENGINEERING, AT-GM-13A Datasheet - Page 9

• Manufacturer Part Number: AT-GM-13A
• Description: AT-GM-13A TWO-HAND CTL RLY
• Manufacturer: BANNER ENGINEERING

If all of the described checks cannot be
verified, the two-hand control system
must not be used until the problem
has been corrected. Injury or death to
personnel may result from attempts to
use the machine under such conditions.
DUO-TOUCH
!
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
WARNING...
Use System Until
Checkouts Are Verified
®
Do Not
SG –
•
Minneapolis MN, U.S.A.
Models AT-GM-13A and AT-HM-13A Two-Hand Control Modules
Daily Checkout:
To be Performed at every Power-up, Shift Change, and Machine Setup Change
Daily checkout and checkouts after tooling and machine setup changes must be
performed by a Designated Person, appointed and identified in writing by the
employer.
1. Verify that all point-of-operation guards are in place and operating properly.
2. Verify that the two actuating devices must be simultaneously engaged to actuate
3. For single-cycle machines: Verify that maintained engagement of the two
4. For part-revolution clutch machinery: Verify that release of either actuating device
5. Verify that the distance from each actuating device to the closest hazard point is
Semi-Annual Checkout:
To be Performed at Six-Month Intervals
This semi-annual checkout must be performed by a Qualified Person.* A copy of test
results should be kept on or near the machine.
1. Perform the daily checkout procedure (see above).
2. Perform the initial checkout procedure (see page 8).
3. Calculate the separation distance (see page 5), and verify that the actuating
4. Verify that the actuating devices are positioned to require the use of both hands
5. Inspect the machine controls and the connections to the DUO-TOUCH SG Safety
* Qualified Person: A person who, by possession of a recognized degree or certificate
of professional training, or who, by extensive knowledge, training, and experience,
has successfully demonstrated the ability to solve problems relating to the
installation, maintenance and use of the DUO-TOUCH SG Two-Hand Control Safety
System.
the machine.
actuating devices results in only one machine cycle.
results in the immediate arrest of the machine motion.
not less than the calculated safety distance (see page 5).
devices are far enough away from the nearest hazard point. Relocate the actuating
devices, if necessary.
for operation, and are protected from false or inadvertent operation.
Module to ensure that wiring is correct, as described on pages 6 and 7, and that
no modifications have been made which could adversely affect the System.
Periodic Checkout and Maintenance
P/N 67241 rev. C
9