162GB16E1626SE608 Amphenol PCD, 162GB16E1626SE608 Datasheet - Page 38
![no-image](/images/manufacturer_photos/0/0/52/amphenol_pcd_sml.jpg)
162GB16E1626SE608
Manufacturer Part Number
162GB16E1626SE608
Description
Conn MIL-C-26482 Circular SKT 26 POS Crimp ST Cable Mount 26 Terminal 1 Port
Manufacturer
Amphenol PCD
Type
MIL-C-26482 Circularr
Datasheet
1.162GB10E1210PC416.pdf
(41 pages)
Specifications of 162GB16E1626SE608
Gender
PL
Termination Method
Crimp
Mounting
Cable Mount
Body Orientation
Straight
INTERNALLY SCREENED JACKETED CABLE TYPE ‘C’
Cable and Wire Stripping
Strip the outer P.V.C. jacket of the cable back to dim ‘A’ to expose the
internal braid. Trim the braid back to within 19.05mm (0.75 in) of
P.V.C. jacket and fold back ‘B’.
FOR 162 SERIES
Strip 5.6mm (0.220 in) to 6.6mm (0.260 in) of insulation from each wire
taking care not to cut or nick strands. If ends fray twist them back to
their original lay.
INITIAL ASSEMBLY
Slide onto the cable the following items in this order (1) Nut (2) Washer
(3) Gasket (4) Braid Clamp (5) 75
CRIMP CONNECTION TO CONTACTS (162 SERIES)
Using the recommended tools, crimp the contacts to the wires and
insert them in the connector as described in the Amform instructions,
which are supplied with each 162 series assembly. Bring up clamp
body taking care not to drag the braid forward. (If necessary a small
amount of thin tape may be used to hold the braid in position whilst
carrying out this operation). Screw the clamp body onto the connector
accessory thread, making sure that the connector serrations engage
with those on the clamp body. Fold the braid out at right angles to the
cable and slide forward the braid clamp. Smooth back braid onto the
braid clamp and trim off the surplus. Slide up gasket, washer, screw
on nut and tighten.
10/12 & 14
Size
08
16
20
24
58.15
66.68
69.85
88.90
95.25
mm
o
A Dimension
Angled Body
INTERNALLY AND EXTERNALLY SCREENED AND UNSCREENED CABLES
2.890
2.625
2.750
3.500
3.750
in
FOR AMPHENOL ANGLED S.J. CLAMPS TO
Assembly Instructions
Surplus Braid
Trimmed
DEF STAN 59-35 (Part 1) Sec. 3 FOR
38