5962-7802301Q2A National Semiconductor, 5962-7802301Q2A Datasheet - Page 7

• Manufacturer Part Number: 5962-7802301Q2A
• Description: Quad Transmitter RS-422 20-Pin CLLCC Rail
• Manufacturer: National Semiconductor

Specifications of 5962-7802301Q2A

• Package: 20CLLCC
• Data Transmission Topology: Multidrop
• Interface Standards: EIA-422
• Function: Line Transmitter
• Number Of Transmitters: 4
• Transmitter Signal Type: Differential
• Transmitter Communication Type: RS-422
• Driving Mode: 3-State
• Typical Single Supply Voltage: 5 V
• Interface Circuit Standard 1: EIA-422
• Number Of Receivers: Not Required
• Number Of Transceivers: Not Required
• Receiver Signal Type: Not Required
• Single Supply Voltage (typ): 5V
• Single Supply Voltage (min): 4.5V
• Single Supply Voltage (max): 5.5V
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Supply Current: 60mA
• Power Supply Requirement: Single
• Operating Temp Range: -55C to 125C
• Operating Temperature Classification: Military
• Mounting: Surface Mount
• Pin Count: 20
• Package Type: LCC
• Lead Free Status / Rohs Status: Not Compliant

Note 1: “Absolute Maximum Ratings” are those values beyond which the safety of the device cannot be guaranteed. They are not meant to imply that the devices
should be operated at these limits. The tables of “Electrical Characteristics” provide conditions for actual device operation.
Note 2: Derate CDip = 11.5 mW/˚C, CLCC = 13mW/˚C, Cerpack = 7.4mW/˚C above 25˚C.
Note 3: Parameter tested go-no-go only.
Note 4: Subgroups 1, 2 and 9, 10: Power dissipation must be externally controlled at elevated temperatures.
Note 5: Pre and post irradiation limits are identical to those listed under AC and DC electrical characteristics. These parts may be dose rate sensitive in a space
environment and demonstrate enhanced low dose rate effect. Radiation end point limits for the noted parameters are guaranteed only for the conditions as specified
in MIL-STD 883, Method 1019, Condition A.
Note 6: Subgroup 10 and 11 guaranteed but not tested.
AC Test Circuit and Switching Time Waveforms
S1 and S2 of load circuit are closed except where shown.
f = 1 MHz, t
f = 1 MHz, t
r
r
≤ 15 ns, t
≤ 15 ns, t
f
f
≤ 6 ns
≤ 6 ns
FIGURE 3. Enable and Disable Times
FIGURE 2. Propagation Delays
FIGURE 1. AC Test Circuit
7
20141203
20141204
20141205
www.national.com