PEF2256EV22NP Lantiq, PEF2256EV22NP Datasheet - Page 341

• Manufacturer Part Number: PEF2256EV22NP
• Manufacturer: Lantiq

Specifications of PEF2256EV22NP

• Number Of Transceivers: 1
• Screening Level: Industrial
• Mounting: Surface Mount
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Lead Free Status / RoHS Status: Supplier Unconfirmed

RME3
RFS3
RDO3
ALLS3
Data Sheet
Receive Message End - HDLC Channel 3
One complete message of length less than 32 bytes, or the last part
of a frame at least 32 bytes long is stored in the receive FIFO3,
including the status byte.
The complete message length can be determined reading register
RBC3, the number of bytes currently stored in RFIFO3 is given by
RBC3(6:0). Additional information is available in register RSIS3.
Receive Frame Start - HDLC Channel 3
This is an early receiver interrupt activated after the start of a valid
frame has been detected, i.e. after an address match (in operation
modes providing address recognition), or after the opening flag
(transparent mode 0) is detected, delayed by two bytes. After an
RFS2 interrupt, the contents of
• RAL1
• RSIS3 bits 3 to 1
are valid and can be read by the CPU.
Receive Data Overflow - HDLC Channel 3
This interrupt status indicates that the CPU did not respond fast
enough to an RPF3 or RME3 interrupt and that data in RFIFO3 has
been lost. Even when this interrupt status is generated, the frame
continues to be received when space in the RFIFO3 is available
again.
Note: Whereas the bit RSIS3.RDO3 in the frame status byte
All Sent - HDLC Channel 3
This bit is set if the last bit of the current frame has been sent
completely and XFIFO3 is empty. This bit is valid in HDLC mode only.
indicates whether an overflow occurred when receiving the
frame currently accessed in the RFIFO3, the ISR5.RDO3
interrupt status is generated as soon as an overflow occurs
and does not necessarily pertain to the frame currently
accessed by the processor.
341
Rev. 1.1, 2005-06-13
PEF 2256 H/E
E1 Registers
FALC
®
56