5962-89815013A E2V, 5962-89815013A Datasheet - Page 10

• Manufacturer Part Number: 5962-89815013A
• Manufacturer: E2V

Specifications of 5962-89815013A

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
883 including groups A, B, C, and D inspections. The following additional criteria shall apply.
appendix A.
prior to quality conformance inspection. The following additional criteria shall apply:
4. VERIFICATION
4.1 Sampling and inspection. Sampling and inspection procedures shall be in accordance with MIL-PRF-38535,
4.2 Screening. Screening shall be in accordance with method 5004 of MIL-STD-883, and shall be conducted on all devices
4.3 Quality conformance inspection. Quality conformance inspection shall be in accordance with method 5005 of MIL-STD-
4.3.1 Group A inspection.
a.
b.
a.
b.
c.
(1) Test condition D. The test circuit shall be maintained by the manufacturer under document revision level control
(2) T
DEFENSE SUPPLY CENTER COLUMBUS
Burn-in test, method 1015 of MIL-STD-883.
Interim and final electrical test parameters shall be as specified in table II herein, except interim electrical parameter
tests prior to burn-in are optional at the discretion of the manufacturer.
Tests shall be as specified in table II herein.
Subgroups 5 and 6 in table I, method 5005 of MIL-STD-883 shall be omitted.
Subgroup 4 (C
changes which may affect input or output capacitance. Sample size is 15 devices with no failures, and all input and
output terminals tested.
and shall be made available to the preparing or acquiring activity upon request. The test circuit shall specify the
inputs, outputs, biases, and power dissipation, as applicable, in accordance with the intent specified in method 1015
of MIL-STD-883.
A
MICROCIRCUIT DRAWING
= +125°C, minimum.
COLUMBUS, OHIO 43218-3990
STANDARD
IN
and C
Interim electrical parameters
Final electrical test parameters
Group A test requirements
Groups C and D end-point
1/
2/
3/
(method 5004)
(method 5004)
(method 5005)
electrical parameters
(method 5005)
OUT
MIL-STD-883 test requirements
measurement) shall be measured only for the initial test and after process or design
* Indicates PDA applies to subgroups 1 and 7.
Any or all subgroups may be combined when using
high-speed testers.
** See 4.3.1c.
TABLE II. Electrical test requirements.
SIZE
A
1
1*, 2, 3, 7*, 8A, 8B, 9, 10, 11
1, 2, 3, 4**,7, 8A, 8B, 9, 10, 11
2, 3, 7, 8A, 8B
MIL-STD-883, method 5005,
(in accordance with
Subgroups
REVISION LEVEL
table I)
B
SHEET
5962-89815
10