MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 64

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Note:
4.8
4.9
4.10
4.10.1
4.10.2
Intel NetStructure
Technical Product Specification
64
®
A digital ground is also known as a logic ground. A chassis ground is also known as a
shelf ground.
EFI BIOS Configuration
In most cases, the EFI BIOS defaults provide the correct configuration for board use.
However, a user that needs to make changes to the default EFI settings can refer to
Chapter 7.0, “EFI BIOS Setup,”
Remote Access Configuration
Console redirection to the front panel serial port is enabled by default. This setting
redirects the text output of the EFI BIOS and operating system to the RJ-45 serial port
on the MPCBL0050 faceplate. Remote access using serial console redirection allows
users to monitor the boot process and run the EFI BIOS setup from a remote serial
terminal. The default settings are 115200, N, 8, 1 with no flow control. Use these
settings to access the console data. See
interface.
Boot Devices
The EFI BIOS Setup program includes a choice of available boot devices, with each boot
device having options for removable media (USB CD-ROM, USB flash disk, etc.), SAS
hard drive, on-board PATA flash drives, or PXE boot through any of the six GbE
adapters.
In every POST, the EFI BIOS detects all available boot devices and displays them on the
boot order screen.
Refer to
Booting from a SAS Hard Disk
If the MPRTM0050 RTM equipped with SAS HDD is installed the HDD can be used for
booting the operating system. Refer to
boot devices.
Booting from a PATA Flash (On-board)
Two Parallel ATA flashes are available on the board. Each of them can be used for
booting operating system.
4. From the plastic parts bag included in the box with the MPCBL0050, remove the
5. Slide the washer on to the threaded end of the replacement standoff.
6. With the plastic washer in place, carefully thread the new standoff into the board
7. Replace the memory top cover that was removed in step 2.
MPCBL0050 Single Board Computer
replacement metal standoff and white plastic washer.
where the old standoff was removed in step 3. Using a flat head torque screwdriver,
tighten the standoff/washer combination into place with a torque of 4 in-lbs.
— Be sure not to confuse the removed standoff with the replacement standoff.
— With the white washer properly in place with the replacement standoff, the
They are similar but not identical.
digital ground is now isolated from the chassis ground.
Section 7.6
for detailed information on selecting boot devices.
for a complete description of the EFI options.
Section 7.6
Section 3.1.2
for detailed information on selecting
for the pin description of this
MPCBL0050—Operating the Unit
Order Number: 318146-001
September 2007