EP1S30F780I6N Altera, EP1S30F780I6N Datasheet - Page 162

IC STRATIX FPGA 30K LE 780-FBGA

EP1S30F780I6N

Manufacturer Part Number
EP1S30F780I6N
Description
IC STRATIX FPGA 30K LE 780-FBGA
Manufacturer
Altera
Series
Stratix®r
Datasheet

Specifications of EP1S30F780I6N

Number Of Logic Elements/cells
32470
Number Of Labs/clbs
3247
Total Ram Bits
3317184
Number Of I /o
597
Voltage - Supply
1.425 V ~ 1.575 V
Mounting Type
Surface Mount
Operating Temperature
-40°C ~ 100°C
Package / Case
780-FBGA
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Number Of Gates
-

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
EP1S30F780I6N
Manufacturer:
ALTERA
Quantity:
996
Part Number:
EP1S30F780I6N
Manufacturer:
Altera
Quantity:
10 000
Part Number:
EP1S30F780I6N
Manufacturer:
ALTERA
0
Configuration
3–8
Stratix Device Handbook, Volume 1
synthesis, allowing real-time variation of the PLL frequency and delay.
The rest of the device is functional while reconfiguring the PLL. See the
Stratix Architecture chapter of the Stratix Device Handbook, Volume 1 for
more information on Stratix PLLs.
Remote Update Configuration Modes
Stratix devices also support remote configuration using an Altera
enhanced configuration device (e.g., EPC16, EPC8, and EPC4 devices)
with page mode selection. Factory configuration data is stored in the
default page of the configuration device. This is the default configuration
that contains the design required to control remote updates and handle
or recover from errors. You write the factory configuration once into the
flash memory or configuration device. Remote update data can update
any of the remaining pages of the configuration device. If there is an error
or corruption in a remote update configuration, the configuration device
reverts back to the factory configuration information.
There are two remote configuration modes: remote and local
configuration. You can use the remote update configuration mode for all
three configuration modes: serial, parallel synchronous, and parallel
asynchronous. Configuration devices (for example, EPC16 devices) only
support serial and parallel synchronous modes. Asynchronous parallel
mode allows remote updates when an intelligent host is used to configure
the Stratix device. This host must support page mode settings similar to
an EPC16 device.
Remote Update Mode
When the Stratix device is first powered up in remote update
programming mode, it loads the configuration located at page address
“000.” The factory configuration should always be located at page
address “000,” and should never be remotely updated. The factory
configuration contains the required logic to perform the following
operations:
The factory configuration is the default and takes control if an error
occurs while loading the application configuration.
Determine the page address/load location for the next application’s
configuration data
Recover from a previous configuration error
Receive new configuration data and write it into the configuration
device
Altera Corporation
July 2005