EZ80L92AZ050SG Zilog, EZ80L92AZ050SG Datasheet - Page 112

• Manufacturer Part Number: EZ80L92AZ050SG
• Description: IC WEBSERVER 50MHZ 100LQFP
• Manufacturer: Zilog

Specifications of EZ80L92AZ050SG

• Processor Type: eZ80
• Features: High Speed, Single-Cycle Instruction-Fetch
• Speed: 50MHz
• Voltage: 3.3V
• Mounting Type: Surface Mount
• Package / Case: 100-LQFP
• Processor Series: EZ80L92x
• Core: eZ80
• Data Bus Width: 8 bit
• Program Memory Size: 64 KB
• Interface Type: I2C, SPI, UART
• Maximum Clock Frequency: 50 MHz
• Number Of Programmable I/os: 24
• Number Of Timers: 6
• Operating Supply Voltage: 3 V to 3.6 V
• Maximum Operating Temperature: + 70 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: eZ80L920210ZCO
• Minimum Operating Temperature: 0 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-3878; EZ80L92AZ050SG

PS013014-0107
UART Interrupts
is reset only when the processor reads all of the received data bytes. If the number of bits
received is less than eight, the unused most significant bits of the data byte Read are 0.
The receiver uses the clock from the BRG for receiving the data. This clock must be 16
times the appropriate baud rate. The receiver synchronizes the shift clock on the falling
edge of the RxD input start bit. It then receives a complete byte according to the set
parameters. The receiver also implements logic to detect framing errors, parity errors,
overrun errors, and break signals.
UART Modem Control
The modem control logic provides two outputs and four inputs for handshaking with the
modem. Any change in the modem status inputs, except RI, is detected and an interrupt
can be generated. For RI, an interrupt is generated only when the trailing edge of the RI is
detected. The module also provides LOOP mode for self-diagnostics.
There are five different sources of interrupts from the UART are:
•
•
•
UART Transmitter Interrupt
The transmitter interrupt is generated if there is no data available for transmission. This
interrupt can be disabled using the individual interrupt enable bit or cleared by writing
data into the UARTx_THR register.
UART Receiver Interrupts
A receiver interrupt can be generated by three possible sources. The first source, a receiver
data ready, indicates that one or more data bytes are received and are ready to be read. This
interrupt is generated if the number of bytes in the receiver FIFO is greater than or equal to
the trigger level. If the FIFO is not enabled, the interrupt is generated if the receive buffer
contains a data byte. This interrupt is cleared by reading the UARTx_RBR.
The second interrupt source is the receiver time-out. A receiver time-out interrupt is gen-
erated when there are fewer data bytes in the receiver FIFO than the trigger level and there
are no Reads and Writes to or from the receiver FIFO for four consecutive byte times.
When the receiver time-out interrupt is generated, it is cleared only after emptying the
entire receive FIFO.
The first two interrupt sources from the receiver (data ready and time-out) share an
interrupt enable bit.
Transmitter.
Receiver (three different interrupts).
Modem status.
Universal Asynchronous Receiver/Transmitter
Product Specification
eZ80L92 MCU
106