HD64F2168VTE33 Renesas Electronics America, HD64F2168VTE33 Datasheet - Page 110

• Manufacturer Part Number: HD64F2168VTE33
• Manufacturer: Renesas Electronics America

Specifications of HD64F2168VTE33

• Cpu Family: H8S
• Device Core Size: 16/32Bit
• Frequency (max): 33MHz
• Interface Type: I2C/IrDA/SCI
• Program Memory Type: Flash
• Program Memory Size: 256KB
• Total Internal Ram Size: 40KB
• # I/os (max): 106
• Number Of Timers - General Purpose: 5
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• On-chip Adc: 8-chx10-bit
• On-chip Dac: 2-chx8-bit
• Instruction Set Architecture: CISC
• Operating Temp Range: -20C to 75C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 144
• Package Type: TQFP
• Lead Free Status / Rohs Status: Not Compliant

4.4
Interrupts are controlled by the interrupt controller. The sources to start interrupt exception
handling are external interrupt sources (NMI, IRQ15 to IRQ0, KIN15 to KIN0, and WUE15 to
WUE8) and internal interrupt sources from the on-chip peripheral modules. NMI is an interrupt
with the highest priority. For details, see section 5, Interrupt Controller.
Interrupt exception handling is conducted as follows:
1. The values in the program counter (PC) and condition code register (CCR) are saved to the
2. A vector address corresponding to the interrupt source is generated, the start address is loaded
4.5
Trap instruction exception handling starts when a TRAPA instruction is executed. Trap instruction
exception handling can be executed at all times in the program execution state.
Trap instruction exception handling is conducted as follows:
1. The values in the program counter (PC) and condition code register (CCR) are saved to the
2. A vector address corresponding to the interrupt source is generated, the start address is loaded
The TRAPA instruction fetches a start address from a vector table entry corresponding to a vector
number from 0 to 3, as specified in the instruction code.
Table 4.3 shows the status of CCR after execution of trap instruction exception handling.
Table 4.3
Rev. 3.00, 03/04, page 68 of 830
Interrupt Control Mode
0
1
stack.
from the vector table to the PC, and program execution begins from that address.
stack.
from the vector table to the PC, and program execution starts from that address.
Interrupt Exception Handling
Trap Instruction Exception Handling
Status of CCR after Trap Instruction Exception Handling
I
Set to 1
Set to 1
CCR
UI
Retains value prior to
execution
Set to 1