MX29LA129ML Macronix International, MX29LA129ML Datasheet - Page 21

• Manufacturer Part Number: MX29LA129ML
• Description: 128M-BIT SINGLE VOLTAGE 3V ONLY UNIFORM SECTOR FLASH MEMORY
• Manufacturer: Macronix International

www.DataSheet4U.com
Legend:
X=Don't care
RA=Address of the memory location to be read.
RD=Data read from location RA during read operation.
PA=Address of the memory location to be programmed.
Addresses are latched on the falling edge of the WE# or
CEx pulse, whichever happen later.
DDI=Data of device identifier
C2H for manufacture code
Notes:
1. See Table 1 for descriptions of bus operations.
2. All values are in hexadecimal.
3. Except when reading array or automatic select data, all bus cycles are write operation.
4. Address bits are don't care for unlock and command cycles, except when PA or SA is required.
5. No unlock or command cycles required when device is in read mode.
6. The Reset command is required to return to the read mode when the device is in the automatic select mode or if
7. The fourth cycle of the automatic select command sequence is a read cycle.
8. The device ID must be read in three cycles. The data is 01h for top boot and 00h for bottom boot.
9. If WP# protects the highest address sectors, the data is 98h for factory locked and 18h for not factory locked. If
10. The data is 00h for an unprotected sector/sector block and 01h for a protected sector/sector block.
11. The total number of cycles in the command sequence is determined by the number of words written to the write
12. Command sequence resets device for next command after aborted write-to-buffer operation.
13. The system may read and program functions in non-erasing sectors, or enter the automatic select mode, when in
14. The Erase Resume command is valid only during the Erase Suspend mode.
15. Command is valid when device is ready to read array data or when device is in automatic select mode.
P/N:PM1171
Q5 goes high.
WP# protects the lowest address sectors, the data is 88h for factory locked and 08h for not factor locked.
buffer. The maximum number of cycles in the command sequence is 21(Word Mode) / 37(Byte Mode).
the erase Suspend mode. The Erase Suspend command is valid only during a sector erase operation.
21
MX29LA129M H/L
PD=Data to be programmed at location PA. Data is latched
on the rising edge of WE# or CEx pulse.
SA=Address of the sector to be erase or verified (in
autoselect mode).
Address bits A23-A16 uniquely select any sector.
WBL=Write Buffer Location. Address must be within the
same write buffer page as PA.
WC=Word Count. Number of write buffer locations to load
minus 1.
BC=Byte Count. Number of write buffer locations to load
minus 1.
REV. 1.0, FEB. 27, 2006