upd78f0124m6gba1-8et Renesas Electronics Corporation., upd78f0124m6gba1-8et Datasheet - Page 132

• Manufacturer Part Number: upd78f0124m6gba1-8et
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: Renesas Electronics Corporation.

(1) 16-bit timer counter 00 (TM00)
(2) 16-bit timer capture/compare register 000 (CR000)
132
TM00 is a 16-bit read-only register that counts count pulses.
The counter is incremented in synchronization with the rising edge of the input clock.
The count value is reset to 0000H in the following cases.
<1> At RESET input
<2> If TMC003 and TMC002 are cleared
<3> If the valid edge of TI000 is input in the mode in which clear & start occurs when inputting the valid edge of
<4> If TM00 and CR000 match in the mode in which clear & start occurs on a match of TM00 and CR000
<5> OSPT00 is set to 1 in one-shot pulse output mode
CR000 is a 16-bit register that has the functions of both a capture register and a compare register. Whether it is
used as a capture register or as a compare register is set by bit 0 (CRC000) of capture/compare control register
00 (CRC00).
CR000 can be set by a 16-bit memory manipulation instruction.
RESET input clears this register to 0000H.
• When CR000 is used as a compare register
• When CR000 is used as a capture register
The value set in CR000 is constantly compared with the 16-bit timer counter 00 (TM00) count value, and an
interrupt request (INTTM000) is generated if they match. The set value is held until CR000 is rewritten.
It is possible to select the valid edge of the TI000 pin or the TI010 pin as the capture trigger. The TI000 or
TI010 valid edge is set using prescaler mode register 00 (PRM00) (see Table 6-2).
TI000
Address: FF10H, FF11H
Symbol
Address: FF12H, FF13H
Symbol
CR000
TM00
Figure 6-3. Format of 16-Bit Timer Capture/Compare Register 000 (CR000)
Figure 6-2. Format of 16-Bit Timer Counter 00 (TM00)
CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00
FF11H
FF13H
After reset: 0000H
After reset: 0000H
User’s Manual U16315EJ3V1UD
R/W
R
FF10H
FF12H