pef20550 Infineon Technologies Corporation, pef20550 Datasheet - Page 349
pef20550
Manufacturer Part Number
pef20550
Description
Extended Line Card Interface Controller Elic
Manufacturer
Infineon Technologies Corporation
Datasheet
1.PEF20550.pdf
(407 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
pef20550H
Manufacturer:
FAI
Quantity:
543
- Current page: 349 of 407
- Download datasheet (3Mb)
PEB 20550
PEF 20550
Application Hints
5.9.2.2 Small PBX
Figure 118 shows a realization example of a small PBX. If the total number of lines
(internal or external) is smaller than the capacity of the ELIC (32
(2
B + D) or 64
B),
the PCM interface of the ELIC need not to be connected to a switching network since all
the B (and D) channel switching can be done inside the ELIC. In this special case, it is
sufficient to apply only a PCM clock to the ELIC, the PCM frame synchronization signal
(8 kHz) can be omitted. The IOM-2 clock and framing signals DCL and FSC are still
generated correctly by the ELIC. The STAR:PSS bit should then not be evaluated: it
stays at logical 0 all the time.
The PBX shown in the figure 118 offers 8 analog (t/r) subscriber lines, realized with two
quadruple codec/filter devices SICOFI-4 (PEB 2465) and one digital, so subscriber
interface realized with the SBCX (PEB2081).
The figure 119 also shows a digital trunk line (external line) which is realized with a U
-
k
layer-1 device, IEC-Q (PEB 2091), operated in NT-PABX mode. The PBX can therefore
be connected directly to the U
interface coming from the CO. The NT-PABX mode of
k
the U
- layer-1 devices is similar to the LT-T mode of the S layer-1 devices: in both cases
k
the layer-1 device delivers a reference clock which is synchronous to the received S or
U
- frame and that can be used to synchronize the local PBX clock generator. Any phase
k
differences between the local IOM-2 frame and the received S or U
- frame are
k
compensated for in an elastic buffer inside the layer-1 devices.
Signaling control for the S
subscriber interface is performed by the ELIC SACCO-A
0
HDLC controller.
Since the digital trunk line also needs a D channel handler, the ELIC SACCO-B HDLC
controller is assigned to that IOM-2 channel.
Semiconductor Group
349
01.96
Related parts for pef20550
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
PHASE SHIFTERS
Manufacturer:
ETC2 [List of Unclassifed Manufacturers]
Datasheet:
Part Number:
Description:
PHASE SHIFTERS
Manufacturer:
MERRIMAC [Merrimac Industries, Inc.]
Datasheet:
Part Number:
Description:
Antenna Switch Silicon Pin Diode
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Silicon Switching Diodes
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Single Igbt Driver Ic
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Igbt Modules
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Igbt Modules
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Igbt Modules
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
5 Volt Standard Regulator
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Active Biased Transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
N-channel Small Signal Mosfet 20v?800v
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Sipmos Small-signal Transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Complementary Mosfets 60v Small-signal-transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Complementary Mosfets 60v
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
P-channel Mosfets Power-transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet: