w25q32bv Winbond Electronics Corp America, w25q32bv Datasheet - Page 52

• Manufacturer Part Number: w25q32bv
• Description: 32m-bit Serial Flash Memory With Dual And Quad Spi
• Manufacturer: Winbond Electronics Corp America

11.2.32 Read Manufacturer / Device ID Dual I/O (92h)
The Read Manufacturer / Device ID Dual I/O instruction is an alternative to the Read Manufacturer /
Device ID instruction that provides both the JEDEC assigned manufacturer ID and the specific device ID
at 2x speed.
The Read Manufacturer / Device ID Dual I/O instruction is similar to the Fast Read Dual I/O instruction.
The instruction is initiated by driving the /CS pin low and shifting the instruction code “92h” followed by a
24-bit address (A23-A0) of 000000h, but with the capability to input the Address bits two bits per clock.
After which, the Manufacturer ID for Winbond (EFh) and the Device ID are shifted out 2 bits per clock on
the falling edge of CLK with most significant bits (MSB) first as shown in figure 31. The Device ID values
for the W25Q32BV is listed in Manufacturer and Device Identification table. If the 24-bit address is initially
set to 000001h the Device ID will be read first and then followed by the Manufacturer ID. The
Manufacturer and Device IDs can be read continuously, alternating from one to the other. The instruction
is completed by driving /CS high.
Note:
The “Continuous Read Mode” bits M(7-0) must be set to Fxh to be compatible with Fast Read Dual I/O instruction.
Figure 31. Read Manufacturer / Device ID Dual I/O Diagram
- 52 -
W25Q32BV