ST16 STMICROELECTRONICS [STMicroelectronics], ST16 Datasheet - Page 12
ST16
Manufacturer Part Number
ST16
Description
CHIP SET INTERFACE SPECIFICATION
Manufacturer
STMICROELECTRONICS [STMicroelectronics]
Datasheet
1.ST16.pdf
(21 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ST1633I-N48
Manufacturer:
ST
Quantity:
20 000
Company:
Part Number:
ST168
Manufacturer:
MINI
Quantity:
23 080
Part Number:
ST1684M
Manufacturer:
ST
Quantity:
20 000
ST16-19RFRDCS
FSD_CHIPSET_B/0104VP2
1.5 STATUS REGISTER
There is only one status register (for reception). This register can be read at the end of each reception. Its
contents is modified by the end of frame interruption. It provides the status of the last received frame.
In order to access this register, after the last byte received in reception, take the Mic_Ctrl_Data line high
and then read the data.
Rx_Speed_Value: Reception Rate ("00"=106K, "01"=212K, "10"=424K, "11"=424K). Comment: If the
configuration bit Rx_Speed_Config is setting the speed, these bits are the same as configuration bits.
Rx_CRC_OK: CRC Status of the frame (’1’= Wrong, ’0’= OK).
Rx_EGT_TooLong: Bit used to indicate EGT overrun during reception.
Rx_Bad_StopBit: Bit used to indicate if a stop bit wasn’t at ’1’ during frame reception.This is may be due
to bad synchronization.
If there is any mistake during the reception, this one will be stopped. In this case, the status register must
be read to know the failure.
6/15