LTC1647 LINER [Linear Technology], LTC1647 Datasheet - Page 10

• Manufacturer Part Number: LTC1647
• Description: Hot Swap Controller
• Manufacturer: LINER [Linear Technology]

LTC4211
TYPICAL PERFORMANCE CHARACTERISTICS
RESET (Pin 1/Pin 1): An open-drain output that pulls to
GND if the voltage at the FB pin (Pin 5/Pin 6) falls below
the FB pin threshold (1.236V). During the start-up cycle,
the RESET pin goes high impedance at the end of the
second timing cycle after the FB pin goes above the FB
threshold. This pin requires an external pull-up resistor
to V
RESET pin pulls low independently of the FB pin to prevent
false glitches.
ON (Pin 2/Pin 2): An active high signal used to enable or
disable LTC4211 operation. COMP1’s high-to-low thresh-
old is set at 1.236V and its hysteresis is set at 80mV. If a
logic high signal is applied to the ON pin (V
the first timing cycle begins if an overvoltage condition
does not exist on the GATE pin (Pin 6/Pin 7). If a logic
low signal is applied to the ON pin (V
GATE pin is pulled low by an internal 200μA current sink.
The ON pin can also be used to reset the electronic circuit
breaker. If the ON pin is cycled low and then high following
a circuit breaker trip, the internal circuit breaker is reset,
and the LTC4211 begins a new start-up cycle.
PIN FUNCTIONS
10
CC
. If an undervoltage lockout condition occurs, the
0.5
0.4
0.1
0.3
0.2
0
0
GATE Overvoltage Lockout Threshold
vs Supply Voltage
T
A
= 25°C
2
4
SUPPLY VOLTAGE (V)
6
(8-Lead Package/10-Lead Package)
8
10
12
14
ON
16
< 1.236V), the
18
4211 G52
ON
20
> 1.316V),
TIMER (Pin 3/Pin 4): A capacitor connected from this pin
to GND sets the LTC4211’s system timing. The LTC4211’s
initial and second start-up timing cycles and its internal
“power good” delay time are defined by this capacitor.
GND (Pin 4/Pin 5): Device Ground Connection. Connect
this pin to the system’s analog ground plane.
FB (Pin 5/Pin 6): The FB (Feedback) pin is an input to the
COMP2 comparator and monitors the output supply voltage
through an external resistor divider. If V
RESET pin pulls low. An internal glitch filter at COMP2’s
output helps prevent negative voltage transients from
triggering a reset condition. If V
pin goes high at the end of the second timing cycle.
GATE (Pin 6/Pin 7): The output signal at this pin is the
high side gate drive for the external N-channel FET pass
transistor.
As shown in the Block Diagram, an internal charge pump
supplies a 10μA gate current and sufficient gate volt-
age drive to the external FET for supply voltages from
2.5V to 16.5V. The internal charge-pump and zener
0.4
0.2
0.5
0.3
0.1
0
–75
GATE Overvoltage Lockout Threshold
vs Temperature
V
CC
–50
= 5V
–25
TEMPERATURE (°C)
0
25
50
75 100 125
FB
> 1.239V, the RESET
4211 G53
FB
150
< 1.236V, the
4211fb