HD6417618 RENESAS [Renesas Technology Corp], HD6417618 Datasheet - Page 422

• Manufacturer Part Number: HD6417618
• Description: 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7618 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 14 Serial Communication Interface with FIFO (SCIF)
6. Prohibited Multiple Pin Allocation for Channel 1
7. States of the TxD and RTS Pins When the TE Bit is Cleared
8. Interval from when the TE bit in SCSCR is Set to 1 until a Start Bit is Transmitted in
Rev. 6.00 Jun. 12, 2007 Page 390 of 610
REJ09B0131-0600
Equation 1:
Where: M: Receive margin (%)
From equation 1, if F = 0 and D = 0.5, the receive margin is 46.875%, as given by equation 2.
Equation 2:
When D = 0.5 and F = 0:
M
This is a theoretical value. A reasonable margin to allow in system designs is 20% to 30%.
Although signal SCK1, RxD1, or TxD1 can be assigned to pin PD4 or PE20, either of the pin
must be selected. For example, if signal SCK1 is assigned to both pins PD4 and PE20, correct
operation of the SCIF is not guaranteed. Similarly, signal SCK1, RxD1, or TxD1 can be
assigned to pin PD3 or PE19 and pin PD2 or PE18, respectively. However if these signals are
assigned to both corresponding pins, correct operation of the SCIF is not guaranteed.
The TxDi (i = 0, 1, 2) and RTSj (j = 0, 1) pins usually function as output pins during serial
communication. However, even if these functions are selected by the pin function controller
(PFC), these pins are in the high impedance state as long as the TE bit in SCSCRi (i = 0, 1, 2)
is cleared. To make these pins always function as output pins (regardless of the value of the TE
bit), set SCPTRi (i = 0, 1, 2) and PFC in the following order.
a. Set the SPBIO and SPBDT bits in SCPTRi (i = 0, 1, 2). Set the RTSIO and RTSDT bits in
b. Select the TxDi (i = 0, 1, 2) and RTSj (j = 0, 1) pins by the PFC.
Asynchronous Mode
In the SCIF included in former products, a start bit is transmitted after the internal equivalent
to one frame. In the SCIF included in this product, however, a start bit is transmitted directly
after the TE bit is set to 1.
SCPTRj (j = 0, 1).
M = (0.5 -
N: Ratio of clock frequency to bit rate (N = 16)
D: Clock duty cycle (D = 0 to 1.0)
L: Frame length (L = 9 to 12)
F: Absolute deviation of clock frequency
= (0.5 – 1/(2 × 16)) × 100%
= 46.875%
2N
1
) = (L - 0.5) F -
D - 0.5
N
(1+F) × 100 %