SMT10E ARTESYN [Artesyn Technologies], SMT10E Datasheet - Page 31

• Manufacturer Part Number: SMT10E
• Description: 3.0 Vin to 5.5 Vin Single output
• Manufacturer: ARTESYN [Artesyn Technologies]

Note 1
Thermal reference is defined as the highest temperature
measured at any one of the specified thermal reference points.
See Figure 50: Thermal reference points.
Note 2
The Remote ON/OFF pin is referenced to ground.
Note 3
The SMT10E features a ‘Negative Logic’ Remote ON/OFF
operation. If not using the Remote ON/OFF pin, leave the pin
open (the converter will be on). The Remote ON/OFF pin is
referenced to ground.
The following conditions apply for the SMT10E:
Configuration
Remote pin open circuit
Remote pin pulled low
Remote pin pulled high [Von/off >1.2V] Unit is OFF
A ‘Positive Logic’ Remote ON/OFF version is also possible
with this converter. To order please place the suffix ‘-R’ at the
end of the model number, e.g. SMT10E-05W3V3-RJ.
Note 4
Thermal reference set up: Unit mounted on an edge card test
board 203mm x 190mm. Test board mounted vertically. For test
details and recommended set-up see Application Note 168.
CAUTION: Hazardous internal voltages and high temperatures.
Ensure that unit is accessible only to trained personnel. The user
must provide the recommended fusing in order to comply with
safety approvals.
31
www.artesyn.com
Converter Operation
Unit is ON
Unit is ON
Figure 50: Thermal Reference Points
Case Temperature should not exceed 115ºC
SMT10E Series | 10 A DC-DC Converter
Direction of Airflow
File Name: lf_smt10e_05.pdf Rev (02): 04 Jan 2006
E Class Non-Isolated