IS75V16F128GS32-7065BI ISSI [Integrated Silicon Solution, Inc], IS75V16F128GS32-7065BI Datasheet - Page 20

• Manufacturer Part Number: IS75V16F128GS32-7065BI
• Description: 3.0 Volt Multi-Chip Package (MCP) 128 Mbit Simultaneous Operation Flash Memory and 32 Mbit Pseudo Static RAM
• Manufacturer: ISSI [Integrated Silicon Solution, Inc]

IS75V16F128GS32
FLASH MEMORY COMMAND DEFINITIONS - FLASH 1 or FLASH 2
Notes:
•
•
•
•
•
20
Address bits A21 to A11 = X = “H” or “L” for all
address commands except or Program Address
(PA), Sector Address (SA), and Bank Address
(BA), and Sector Group Address (SPA).
Bus operations are defined in "DEVICE BUS
OPERATIONS”.
RA = Address of the memory location to be read
PA = Address of the memory location to be
programmed. Addresses are latched on the falling
edge of the write pulse.
SA = Address of the sector to be erased. The
combination of A21, A20, A19, A18, A17, A16,
A15, A14, A13, and A12 will uniquely select any
sector. BA = Bank Address (A21, A20, A19)
RD = Data read from location RA during read
operation.
PD = Data to be programmed at location PA. Data
is latched on the rising edge of the write pulse.
Integrated Silicon Solution, Inc. — www.issi.com —
•
•
•
•
•
SPA = Sector group address to be protected.
Set sector group address and (A6, A3, A2, A1,
A0) = (0, 0, 0, 1, 0).
SD = Sector group protection verify data.
Output 01h at protected sector group
addresses and output 00h at unprotected
sector group addresses.
HRA = Address of the Hi-ROM area :
000000h to 00007Fh
HRBA = Bank Address of the Hi-ROM area
(A21 = A20 = A19 = VIL)
The system should generate the following address
patterns : 555h or 2AAh to addresses A10 to A0
Both Read/Reset commands are functionally
equivalent, resetting the device to the read mode.
Command combinations not described in FLASH
Memory Command Definitions are illegal.
(Continued)
PRELIMINARY INFORMATION Rev. 00D
ISSI
1-800-379-4774
03/24/03
®