WIZ110SR WIZnet, WIZ110SR Datasheet - Page 14

• Manufacturer Part Number: WIZ110SR
• Description: Ethernet Modules BOARD TYPE SERIAL-ENET MOD
• Manufacturer: WIZnet

Specifications of WIZ110SR

• Rohs: yes
• Product: Serial to Ethernet Modules
• Interface Type: RS-232
• Operating Supply Voltage: 5 V
• Maximum Operating Temperature: + 70 C
• Dimensions: 75 mm x 45 mm
• Minimum Operating Temperature: 0 C

Copyright © WIZnet All Rights Reserved
search modules. Therefore, network information of the module such as IP address, subnet
mask and gateway is required for the search.
If you check Direct IP search, the field in which IP address is input, will be activated. In this
field, input IP address of the module, and click “Search” button.
☞
Check if module is connected to the NAT or private network. If so, it is not possible to
connect to the module from outside.
ⓝ
The Search function is used to search all modules existing on the same LAN. By using UDP
broadcast, all modules on the same subnet will be searched.
The searched module is displayed as MAC address in the “Board list”.
ⓞ
This function is to complete the configuration change.
If you select the MAC address from the “Board list”, the default configuration value of the
module will be displayed. Change the configuration and click “Setting” button to complete
the configuration. The module will re-initialize with the changed configuration. Changed
value is saved in the EEPROM of the module. Thus, the value is not removed even though
power is disconnected.
The configuration value can be changed in below steps.
① Select the MAC address of which configuration value should be changed in the “Board list.
The values configured will be displayed.
② Change the value
③ Click “Setting” button. The configuration change will be complete.
④ The module will be initialized to the changed values (re-booting is processed)
⑤ To check configuration result, click „Search‟ button.
ⓟ
Firmware will be uploaded through network
☞ After uploading the firmware, 20~30 seconds are required for initialization.
ⓠ
If module does not have valid network information, Direct IP search is not available.
Search
Upload
Exit : Close the configuration tool program.
Setting
WIZ110SR | 14 page