MICRO-101 Gravitech, MICRO-101 Datasheet - Page 4

• Manufacturer Part Number: MICRO-101
• Description: Development Boards & Kits - PIC / DSPIC MICRO-101 KIT
• Manufacturer: Gravitech

Specifications of MICRO-101

• Rohs: yes
• Product: Development Platforms
• Tool Is For Evaluation Of: PICAXE
• Core: PIC
• Interface Type: USB
• Operating Supply Voltage: 5 V

SOLDERING/ASSEMBLY TIPS
Disclaimer: Take care not to burn your fingers while soldering. Gravitech will
NOT be responsible for any injuries that occur during assembly of this board.
Consult the parts list and identify the parts to be soldered on the board. Most of the
parts are very small, such as C1, C3, C4, and C5 so make sure you do not drop them
on the floor and lose them. Some of the parts are polarized. These parts need to be
soldered correctly; otherwise they will damage the entire board. The polarized parts
are the following:
QTY
1
1
1
1
1
•
(-) signs on the side of the cap. The positive lead is longer than the negative lead.
Make sure you solder the capacitor correctly, with the (+) lead in the hole marked
with (+) and the (-) lead accordingly.
•
silver band. This band corresponds to the vertical bar on the symbol on the board.
The band must be soldered on the same side with the vertical bar. Two diodes are
soldered with the band on the left side, and two with the band on the right side.
With the nose pliers, bend each lead of each diode to a 90-degree angle and pass
it through the appropriate hole.
•
casing. The positive end (anode) has a longer lead than the negative lead.
100uF electrolytic capacitor (C2): The negative lead is marked with several
D1, D2, D3, and D4 Rectifier diodes: One end of the diode is marked with a
LEDs: The negative end of each LED (cathode) has a flat designator on the
Wire cutter. Select one small enough to get into tight spots
Nose pliers. Select one small enough to get into tight spots.
Soldering iron, 25 Watt. Select one with a fine tip
Solder. Select the fine size
De-soldering wick
MICRO-101 Assembly Instruction Manual
Copyright © 2008 Gravitech
TOOLS REQUIRED FOR ASSEMBLY
WWW.GRAVITECH.US
DESCRIPTION