CBC-EVAL-05B Cymbet, CBC-EVAL-05B Datasheet - Page 7
![no-image](/images/no-image-200.jpg)
CBC-EVAL-05B
Manufacturer Part Number
CBC-EVAL-05B
Description
Power Management IC Development Tools EnerChip CC Evaluaton Kit
Manufacturer
Cymbet
Type
Battery Managementr
Datasheet
1.CBC-EVAL-05B.pdf
(7 pages)
Specifications of CBC-EVAL-05B
Rohs
yes
Product
Power Management Modules
Tool Is For Evaluation Of
CBC3112, CBC3150, CBC3105
Input Voltage
2.5 V to 5.5 V
Dimensions
30.5 mm x 17.2 mm
Interface Type
USB
Tradename
EnerChip
Using the CBC3105-EVAL-05 board
•
•
•
•
•
•
•
•
•
•
•
Ordering Information
U.S. Patent No. 8,044,508. Additional U.S. and Foreign Patents Pending
Disclaimer of Warranties; As Is
The information provided in this data sheet is provided “As Is” and Cymbet Corporation disclaims all representations or warranties of any
kind, express or implied, relating to this data sheet and the Cymbet battery product described herein, including without limitation, the
implied warranties of merchantability, fitness for a particular purpose, non-infringement, title, or any warranties arising out of course of
dealing, course of performance, or usage of trade. Cymbet battery products are not authorized for use in life critical applications. Users
shall confirm suitability of the Cymbet battery product in any products or applications in which the Cymbet battery product is adopted for
use and are solely responsible for all legal, regulatory, and safety-related requirements concerning their products and applications and any
use of the Cymbet battery product described herein in any such product or applications.
DS-72-26 Rev A
Place the 16-pin CBC3105-EVAL-05 module into solderless breadboard or socket with pin 1 in pin 1.
Tie V
When operating under main power, LED D1 (CBC3105) will be illuminated. When operating in battery
backup mode, LED D1 (CBC3105) will not be illuminated.
Tie V
a resistor divider. See the CBC3105 datasheet for switchover voltage details.
Tie the ENABLE pin to V
Tie V
Tie the RESET pin to the interrupt pin of a microcontroller if desired. When operation is under battery
backup mode, the LED will not be illuminated.
Allow the EnerChip CC to charge for at least 30 minutes before attempting to use backup power.
Monitor V
Place current meter between V
Disconnect V
Cymbet Part Number
BAT
MODE
OUT
CBC-EVAL-05B
to V
to V
BAT
to V
CHG
DD
DD
for battery voltage and monitor V
DD
of an RTC, microcontroller or any device requiring power backup.
and the RESET pin will go low and system will switchover to battery backup mode.
©2013 Cymbet Corporation • Tel: +1-763-633-1780 • www.cymbet.com
on the test board.
or GND depending the system voltage and the desired switchover voltage. Optionally, use
Cymbet, the Cymbet logo, and EnerChip are Cymbet Corporation Trademarks
DD
.
BAT
and V
EnerChip CC Evaluation Kit
CHG
to monitor battery charging current if desired.
Description
OUT
for output voltage to the system.
EnerChip CBC-EVAL-05B
Includes two boards
Notes
Page 7 of 7