AC7MDT10-D16/S16 STMicroelectronics, AC7MDT10-D16/S16 Datasheet - Page 35

• Manufacturer Part Number: AC7MDT10-D16/S16
• Description: KIT CONN SDIP16/SO16 ST7MDT10
• Manufacturer: STMicroelectronics

Specifications of AC7MDT10-D16/S16

• Accessory Type: 16-SDIP, 16-SOIC Connection Kit
• For Use With/related Products: ST7MDT10-EMU3 Emulator
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

UM0139
Note:
Figure 25. Removing the TEB
4.
Figure 26. DEB and TEB connectors
5.
For some TEBs, the microcontroller is mounted on a support and not soldered directly to the
board. In this case the TEB’s 84-pin and 64-pin connectors have an additional height of
5mm to allow enough room for the microcontroller. To compensate you will need to add a
The board under the TEB – the Dedicated Emulation Board (DEB), should now be
visible (see
Identify the top and bottom faces of the TEB you wish to install. The bottom face is
distinguished by the presence of two or more flex cable connectors placed side by side.
The top face is distinguishable by two DEB connectors along the long edges of the
TEB. There is one 84-pin connector and one 64-pin connector, which match the DEB
connectors shown in
Install the replacement TEB in the EMU3 probe by inserting the male 84-pin/64-pin
connectors into the TEB’s female 84-pin/64-pin connectors (refer to
Because the connectors are asymmetric, there is only one possible connection
scheme.
with 5mm extension
10mm TEB support
10mm
5mm
Figure
26).
Figure
connectors on the DEB
26.
The 84 and 64-pin
Changing the TEB in your ST7-EMU3 probe
TEB
Figure
26).
35/38