OM6290 NXP Semiconductors, OM6290 Datasheet - Page 23

• Manufacturer Part Number: OM6290
• Description: DEMO BOARD LCD GRAPHIC DRIVER
• Manufacturer: NXP Semiconductors

Specifications of OM6290

• Main Purpose: Displays, LCD Controller
• Embedded: Yes, MCU, 16/32-Bit
• Utilized Ic / Part: PCF2119, PCF8531, PCF8576
• Primary Attributes: Character, Graphic and Segment LCD Drivers
• Secondary Attributes: JTAG, I²C, UART & USB Interfaces
• Description/function: Demo Board
• Interface Type: USB, I2C, JTAG, UART
• Data Bus Width: 4 bit, 8 bit, 16 bit
• Operating Voltage: 1.8 V to 5.5 V
• For Use With/related Products: PCF8576DT, PCF2119S, PCF8531
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 568-4703

NXP Semiconductors
6. Flash Magic Quick Start
UM10300_1
User manual
6.1 Connecting with serial ISP
Setting up the OM6290 board is easy and explanations for the board setup are given
here.
In stand-alone mode only a 9V battery is used to provide power to the board and let the
onboard program run. The board is protected against reversed polarisation of the supply
voltage. Alternatively the USB port can be used to provide power. If also firmware needs
to be modified, the OM6290 board requires a serial connection for In-System
Programming and with a PC already present it is then more economical to use a USB
connection for power. Especially with the backlight fully lit battery lifetime is reduced
which is not an issue if power is supplied via USB. Refer to Chapter 9 for technical data.
When the board is first plugged into the USB port of the PC, Windows will ask for a driver
for ‘Philips LPC2148 VCOM’. The host driver that came with the sample software is
under the "PLPU-S2K" directory.
To connect the OM6290 board for serial programming:
Fig 11. Settings for connecting with serial ISP
• Set switch S1 to position ‘Program Flash’;
• Ensure a jumper is on J3 (can move jumper from J5 for programming);
• Provide power to the board using a standard USB cable. Battery supply will work too,
• Connect a user supplied 9-pin serial cable from a COM port on the PC to RS1 on the
• Verify the COM connection using FlashMagic. To do this:
but since a PC is being used anyway it is recommended to use the option of USB
powering the board;
OM6290 board;
a. Start Flash Magic (using Start – Programs – Flash Magic – Flash Magic) and
configure the COM port interface as indicated below.
Rev. 1.0— 8 August 2008
User Manual OM6290
UM10300
© NXP B.V. 2008. All rights reserved.
23 of 30