STEVAL-PCC010V1 STMicroelectronics, STEVAL-PCC010V1 Datasheet - Page 9

• Manufacturer Part Number: STEVAL-PCC010V1
• Description: BOARD EVAL FOR ST802RT1
• Manufacturer: STMicroelectronics

Specifications of STEVAL-PCC010V1

• Main Purpose: Interface, Ethernet Controller (PHY and MAC)
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST802RT1
• Primary Attributes: 1 Port, 100BASE-TX/10BASE-T
• Secondary Attributes: MII, RMII
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-10360

Getting started
9/37
Figure 4.
2.
3.
4.
5.
6.
Setup properly jumpers on the ST802RT1 TX mode Ethernet PHY demonstration
board. The software does not change any settings of the PHY; it reads the settings
from the PHY instead. See
Connect ST802RT1 TX mode Ethernet PHY board to STM32F107 controller board.
Connect Ethernet cable to the ST802RT1 TX mode Ethernet PHY board on one side
and to the PC on the other side.
Flash the demonstration software into the Flash memory of the STM32F107 MCU.
it is easy to setup any other operating system in a similar way.
a)
Configure your PC. The following description is valid for Windows
Setup network settings: in Control Panel - Network Connections right click your
network card and open Properties.
ST802RT1 TX mode demonstration board connected to STM32F107
demonstration board
Doc ID 16379 Rev 2
Section 6.1
for more details about board setup.
®
XP; nevertheless
UM0819