STEVAL-PSQ001V1 STMicroelectronics, STEVAL-PSQ001V1 Datasheet - Page 28

• Manufacturer Part Number: STEVAL-PSQ001V1
• Description: BOARD EVAL BASED ON PM6680A
• Manufacturer: STMicroelectronics
• Type: Other Power Managementr

Specifications of STEVAL-PSQ001V1

• Design Resources: STEVAL-PSQ001V1 Gerber Files STEVAL-PSQ001V1 Schematic STEVAL-PSQ001V1 Bill of Material
• Main Purpose: DC/DC, Step Down with LDO
• Outputs And Type: 6, Non-Isolated
• Voltage - Output: 0.9 ~ 2.5 V, 1 ~ 3.3 V, 2x 3.3 V, 2.5 V, 5 V
• Current - Output: 4A, 2A, 800mA, 400mA, 400mA, 150mA
• Voltage - Input: 5 ~ 36V
• Regulator Topology: Buck
• Frequency - Switching: 200kHz, 300kHz
• Board Type: Fully Populated
• Utilized Ic / Part: PM6680A
• Input Voltage: 5 V to 36 V
• Output Voltage: 1 V to 3.3 V
• Product: Power Management Modules
• Silicon Manufacturer: ST Micro
• Silicon Core Number: PM6680A
• Kit Application Type: Power Management
• Application Sub Type: Power Supply
• Kit Contents: Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: PM6680A
• Other names: 497-6425; STEVAL-PSQ001V1

Device description
7.11
28/48
Power up sequencing and operative modes
Let us consider SHDN, EN1 and EN2 low at the beginning. An external voltage is applied as
input voltage. The device is in shutdown mode.
When the SHDN pin voltage is above the shutdown device on threshold (1.5 V typ.), the
controller begins the power-up sequence. All the latched faults are cleared. LDO5
undervoltage control is blanked for 4 ms and the internal regulator LDO5 turns on. If the
LDO5 output is above the UVLO threshold after this time, the device enters in standby
mode. The switching outputs are kept to ground by turning on the low side MOSFETs.
When EN1 and EN2 pins are forced high the switching sections begin their soft start
sequence.
Table 8.
Shutdown
Standby
Mode
Run
Operatives modes
SHDN is high,
EN1/EN2 pins are high
Both EN1/EN2 pins are low
and SHDN pin is high
SHDN is low
Conditions
Switching regulators are enabled; internal linear
regulators outputs are enabled.
Internal Linear regulators active (LDO5 is always on).
In Standby mode LGATE1/LGATE2 pins are forced
high while HGATE1/HGATE2 pins are forced low.
All circuits off.
Description
PM6680A