R0K572011S000BE Renesas Electronics America, R0K572011S000BE Datasheet - Page 208

• Manufacturer Part Number: R0K572011S000BE
• Description: KIT STARTER FOR SH7201
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K572011S000BE

• Contents: CPU Board, LCD Display Module, E8 Emulator, Cable, QuickStart Guide and CD-ROM
• For Use With/related Products: SH7201
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Section 7 User Break Controller (UBC)
7.5
1. The CPU can read from or write to the UBC registers via the I bus. Accordingly, during the
2. The UBC cannot monitor access to the C bus and I bus cycles in the same channel.
3. When a user break interrupt request and another exception source occur at the same
4. Note the following when a break occurs in a delay slot.
5. User breaks are disabled during UBC module standby mode. Do not read from or write to the
6. Do not set an address within an interrupt exception handling routine whose interrupt priority
7. Do not set break after instruction execution for the SLEEP instruction or for the delayed
8. When setting a break for a 32-bit instruction, set the address where the upper 16 bits are
9. Do not set a break after instruction execution for the DIVU or DIVS instruction. If a break
10. Do not set a pre-execution break for the instruction that comes after the DIVU or DIVS
11. Do not set a pre-execution break and a break after instruction execution simultaneously in one
Page 180 of 1190
period from executing an instruction to rewrite the UBC register till the new value is actually
rewritten, the desired break may not occur. In order to know the timing when the UBC register
is changed, read from the last written register. Instructions after then are valid for the newly
written register value.
instruction, which has higher priority is determined according to the priority levels defined in
table 5.1 in section 5, Exception Handling. If an exception source with higher priority occurs,
the user break interrupt request is not received.
If a pre-execution break is set at a delay slot instruction, the user break interrupt request is not
received immediately before execution of the branch destination.
UBC registers during UBC module standby mode; the values are not guaranteed.
level is at least 15 (including user break interrupts) as a break address.
branch instruction where the SLEEP instruction is placed at its delay slot.
placed. If the address of the lower 16 bits is set and a break before instruction execution is set
as a break condition, the break is handled as a break after instruction execution.
after instruction execution is set for the DIVU or DIVS instruction and an exception or
interrupt occurs during execution of the DIVU or DIVS instruction, a break after instruction
execution occurs even though execution of the DIVU or DIVS instruction is halted.
instruction. If a pre-execution break is set for the instruction that comes after the DIVU or
DIVS instruction and an exception or interrupt occurs during execution of the DIVU or DIVS
instruction, a pre-execution break occurs even though execution of the DIVU or DIVS
instruction is halted.
address. For example, if a pre-execution break for channel 0 and a break after instruction
execution for channel 1 are set simultaneously for one address, a break generated prior to
instruction execution for channel 0 can set a condition-match flag after the instruction
execution for channel 1.
Usage Notes
R01UH0026EJ0300 Rev. 3.00
SH7201 Group
Sep 24, 2010