E62655RUSB Renesas Electronics America, E62655RUSB Datasheet - Page 155

• Manufacturer Part Number: E62655RUSB
• Description: EMULATOR BASE H8S/2655R W/USB
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of E62655RUSB

• Contents: E6000 Emulator Unit and 4 Logic Probes
• For Use With/related Products: H8S/2655R
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The above contention will not occur if an enable bit or interrupt source flag is cleared to 0 while
the interrupt is masked.
5.5.2
Instructions that disable interrupts are LDC, ANDC, ORC, and XORC. After any of these
instructions is executed, all interrupts including NMI are disabled and the next instruction is
always executed. When the I bit or a UI bit is set by one of these instructions, the new value
becomes valid two states after execution of the instruction ends.
5.5.3
There are times when interrupt acceptance is disabled by the interrupt controller.
The interrupt controller disables interrupt acceptance for a 3-state period after the CPU has
updated the mask level with an LDC, ANDC, ORC, or XORC instruction.
5.5.4
Interrupt operation differs between the EEPMOV.B instruction and the EEPMOV.W instruction.
With the EEPMOV.B instruction, an interrupt request (including NMI) issued during the transfer
is not accepted until the move is completed.
With the EEPMOV.W instruction, if an interrupt request is issued during the transfer, interrupt
exception handling starts at a break in the transfer cycle. The PC value saved on the stack in this
case is the address of the next instruction.
Therefore, if an interrupt is generated during execution of an EEPMOV.W instruction, the
following coding should be used.
L1:
Instructions That Disable Interrupts
Times when Interrupts Are Disabled
Interrupts during Execution of EEPMOV Instruction
EEPMOV.W
MOV.W
BNE
R4,R4
L1
Rev. 5.00 Sep 14, 2006 page 125 of 1060
Section 5 Interrupt Controller
REJ09B0331-0500