849 B&K Precision, 849 Datasheet - Page 83

• Manufacturer Part Number: 849
• Description: PROGRAMMER UNIVERSAL DEVICE
• Manufacturer: B&K Precision
• Type: Universalr

Specifications of 849

• Contents: Programmer, Adapter, Cable, Manual and Software
• For Use With/related Products: Serial EEPROM, MCS51 Series and Atmel AVR Series
• Other names: BK849

Connecting 863 programmer to
PC
Problems
Manipulation with the programmed device
interconnection, and their removing
Switch off the PC and programmer. Insert the connection
cable, included in the 863 programmer delivery, to the free
printer port of PC. If your computer is equipped with only one
printer port, substitute the programmer cable for the printer
cable. Connect the opposite cable end to the programmer.
Screw on both connectors to counter connectors. This is very
important mainly for the connector to programmer. Though
replacing the printer cable by the programmer cable is
uncomfortable, it is not recommended to operate the 863
programmer through a mechanical printer switch. Use of an
electronic printer switch isn't possible.
Connect the mains connector of the power supply (or wall-plug
power supply self) to a mains plug, connect the connector to
the appropriate programmer's connector. Then, on the
programmer lights up LED POWER and the programmer 863
is ready to run. Next switch on the PC and run the control
program.
Caution! If you don't want to switch off your PC when
connecting the 863, proceed as follows:
• When connecting the programmer to the PC: FIRST insert
• When disconnecting the programmer from the PC: FIRST
If you have any problems with 863 ) PC interconnection,
see section Common notes please.
After selection of desired device for your work, you can insert
into the open ZIF socket (the lever is up) and close socket (the
lever is down). The correct orientation of the programmed
device in ZIF socket is shown on the picture near ZIF socket
on the programmer's cover. The programmed device is
necessary to insert into the socket also to remove from the
socket when LED BUSY light off.
Warning! 863 programmer hasn’t protection devices, which
protect the content of programmed device against critical
situations, for example power failures and PC failure
the communications cable and THEN the power-supply
connector.
disconnect the power-supply connector and THEN the
communication cable.
related
83
to
the
863
)
PC