MAX4332ESA+ Maxim Integrated Products, MAX4332ESA+ Datasheet - Page 13

• Manufacturer Part Number: MAX4332ESA+
• Description: IC OP AMP R-R I/O LP 8-SOIC
• Manufacturer: Maxim Integrated Products

Specifications of MAX4332ESA+

• Amplifier Type: General Purpose
• Number Of Circuits: 2
• Output Type: Rail-to-Rail
• Slew Rate: 1.5 V/µs
• Gain Bandwidth Product: 3MHz
• Current - Input Bias: 25nA
• Voltage - Input Offset: 250µV
• Current - Supply: 275µA
• Current - Output / Channel: 20mA
• Voltage - Supply, Single/dual (±): 2.3 V ~ 6.5 V, ±1.15 V ~ 3.25 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Number Of Channels: 2
• Voltage Gain Db: 120 dB
• Common Mode Rejection Ratio (min): 71 dB
• Input Offset Voltage: 0.9 mV
• Operating Supply Voltage: 3 V, 5 V
• Maximum Power Dissipation: 471 mW
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Maximum Dual Supply Voltage: +/- 3.25 V
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• -3db Bandwidth: -
• Lead Free Status / Rohs Status: Details

Figure 9. Power-Up/Down Supply Current
Do not three-state SHDN. Due to the output leakage
currents of three-state devices and the small internal
pull-up current for SHDN, three-stating this pin could
result in indeterminate logic levels, and could adversely
affect op-amp operation.
The logic threshold for SHDN is always referred to V
not GND. When using dual supplies, pull SHDN to V
to place the op amp in shutdown mode.
The MAX4330–MAX4334 operate from a single +2.3V
to +6.5V power supply, or from dual ±1.15V to ±3.25V
supplies. For single-supply operation, bypass the
power supply with a 0.1µF capacitor to ground (V
For dual supplies, bypass both V
own set of capacitors to ground.
Good layout technique helps optimize performance by
decreasing the amount of stray capacitance at the op
amp’s inputs and outputs. To decrease stray capaci-
tance, minimize trace lengths by placing external com-
ponents close to the op amp’s pins.
V
I
CC
CC
Single/Dual/Quad, Low-Power, Single-Supply,
______________________________________________________________________________________
Rail-to-Rail I/O Op Amps with Shutdown
Power Supplies and Layout
5 s/div
CC
and V
1V/div
100 A/div
EE
with their
EE
EE
EE
).
,
Figure 10. Shutdown Output Voltage Enable/Disable
Figure 11. Shutdown Enable/Disable Supply Current
SHDN
SHDN
OUT
I
CC
5 s/div
5 s/div
1V/div
500mV/div
1V/div
100 A/div
13