TC7652CPD Microchip Technology, TC7652CPD Datasheet - Page 4

• Manufacturer Part Number: TC7652CPD
• Description: IC OPAMP CHOPPER STAB LN 14DIP
• Manufacturer: Microchip Technology

Specifications of TC7652CPD

• Slew Rate: 1 V/µs
• Amplifier Type: Chopper (Zero-Drift)
• Number Of Circuits: 1
• Gain Bandwidth Product: 400kHz
• Current - Input Bias: 30pA
• Voltage - Input Offset: 2000µV
• Current - Supply: 1mA
• Voltage - Supply, Single/dual (±): 5 V ~ 16 V, ±2.5 V ~ 8 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Through Hole
• Package / Case: 14-DIP (0.300", 7.62mm)
• Op Amp Type: Low Noise
• No. Of Amplifiers: 1
• Bandwidth: 400kHz
• Supply Voltage Range: 5V To 16V
• Amplifier Case Style: DIP
• No. Of Pins: 14
• Operating Temperature Range: 0°C To +70°C
• Number Of Channels: 1
• Voltage Gain Db: 150 dB
• Common Mode Rejection Ratio (min): 120 dB
• Input Offset Voltage: 0.005 mV
• Supply Current: 3 mA
• Maximum Power Dissipation: 800 mW
• Maximum Operating Temperature: + 70 C
• Mounting Style: Through Hole
• Maximum Dual Supply Voltage: +/- 8 V
• Minimum Operating Temperature: 0 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• Current - Output / Channel: -
• -3db Bandwidth: -
• Lead Free Status / Rohs Status: Details
• Other names: 158-1024; 158-1024

TC7652
TC7652 ELECTRICAL SPECIFICATIONS (CONTINUED)
DS21464B-page 4
Electrical Characteristics: V
I
f
Note 1: Limiting input current to 100µA is recommended to avoid latch-up problems. Typically 1mA is safe however, this is not
S
CH
Symbol
2: Output clamp not connected. See typical characteristics curves for output swing versus clamp current characteristics.
3: See “Output Clamp” under detailed description.
guaranteed.
Supply Current
Internal Chopping Frequency
Clamp ON Current (Note 3)
Clamp OFF Current (Note 3)
Parameter
DD
= +5V, V
SS
= -5V, T
A
= +25°C, unless otherwise indicated.
Min
100
25
—
—
Typ
275
100
1
1
Max
—
—
—
3
Units
mA
Hz
µA
pA
©
2002 Microchip Technology Inc.
No Load
Pins 12 – 14 Open (DIP)
R
-4V ≤ V
L
= 100kΩ
Test Conditions
OUT
< +10V