A24-HASM-450 Digi International/Maxstream, A24-HASM-450 Datasheet - Page 58

• Manufacturer Part Number: A24-HASM-450
• Description: ANT 2.4GHZ DIPOLE HALF-WAVE
• Manufacturer: Digi International/Maxstream
• Series: XPressr

Specifications of A24-HASM-450

• Antenna Type: Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
• Number Of Bands: 1
• Frequency: 2.4GHz
• Vswr: 2
• Gain: 2.1dBi
• Termination: RP-SMA
• Mounting Type: Connector
• Height (max): 4.35" (110.5mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 70000340; Q2724499B

XBee/XBee‐PRO ZigBee OEM RF Modules v1.x1x [2007.06.01]
USB Pin Signals
X-CTU Software
Install
Serial Communications Software
Table D‐03. USB signals and their implantations on the XBee/XBee‐PRO RF Module
Pin
1
2
3
4
X-CTU is a MaxStream-provided software program used to interface with and configure
MaxStream RF Modules. The software application is organized into the following four tabs:
Figure D‐04. X‐CTU User Interface (PC Settings, Range Test, Terminal and Modem Configuration tabs)
NOTE: PC Setting values are visible at the bottom of the Range Test, Terminal and Modem Configura-
tion tabs. A shortcut for editing PC Setting values is available by clicking on any of the values.
Double-click the "setup_X-CTU.exe" file and follow prompts of the installation screens. This file is
located in the 'software' folder of the MaxStream CD and also under the 'Downloads' section of the
following web page: www.maxstream.net/support/downloads.php
Setup
A terminal program is built into the X-CTU Software. Other terminal programs such as
"HyperTerminal" can also be used. When issuing AT Commands through a terminal program
interface, use the following syntax:
Figure D‐05. Syntax for sending AT Commands
Name
VBUS
GND
To use the X-CTU software, a module assembly (An RF module mounted to an interface Board)
must be connected to a serial port of a PC. The interface data rate and parity settings of the
serial port ("PC Settings" tab) must match those of the module (BD (Baud Rate) and NB (Parity)
parameters).
© 2007 Digi International, Inc.
D+
D-
• PC Settings tab - Setup PC serial ports for interfacing with an RF module
• Range Test tab - Test the RF module's range and monitor packets sent and received
• Terminal tab - Set and read RF module parameters using AT Commands
• Modem Configuration tab - Set and read RF module parameters
Transmitted & Received Data
Transmitted & Received Data
Description
Ground Signal
Power
Transmit data to and from the RF module
Transmit data to and from the RF module
Power the RF module
Implementation
Ground
Development Guide
58