MDEV-418-HH-LR8-HS Linx Technologies Inc, MDEV-418-HH-LR8-HS Datasheet - Page 2

• Manufacturer Part Number: MDEV-418-HH-LR8-HS
• Description: KIT DEV TX 418MHZ HS LONG-RANGE
• Manufacturer: Linx Technologies Inc
• Type: Transmitterr

Specifications of MDEV-418-HH-LR8-HS

• Frequency: 418MHz
• Product: RF Development Tools
• Maximum Frequency: 418 MHz
• Supply Voltage (max): 9 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Linx OEM Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

HS SERIES DECODER DEVELOPMENT BOARD
Figure 1: HS Series Decoder Development Board
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
Page 2
3
2
1
9V Battery
Power Jack
On-Off Switch
Voltage Regulator
QS Series USB Module
Prototype Area
Break-Out Header
RP-SMA Antenna Connector
LR Series Receiver
HS Series Decoder
Data Line LEDs
Indicator LEDs
Function Switch
LEARN Button
SEND_KEY Button
CREATE_KEY Button
Key Input Jack (for hardwire key transfer)
IR Receiver Enable Button
IR Key Transfer Phototransistor and Diode (for IR key transfer)
Key Output Jack (for hardwire key transfer)
4
6
5
7
17
13
15
11
18
14
10
9
19
8
12
16
20
USING THE DEVELOPMENT BOARDS
TROUBLESHOOTING
1. On the decoder board, press and hold the LEARN button and then press the
2. To use the infrared key transfer, press the GET_KEY button on the back of the
3. To set Control Permissions, press the LEARN button on the decoder board.
4. While the decoder’s MODE_IND line is flashing, press each button on the
5. After all the desired data lines have been transmitted, press the LEARN button
6. Transmit with one or all of the authorized data lines to confirm that the learn
• Check the batteries to make sure they are not dead.
• Make sure that the baud rate switch is set correctly on the decoder board.
• Make sure that the antenna is connected.
• Make sure that you set the Encryption Key correctly. This key is created by the
• Make sure that you set your Control Permissions correctly. If you have not set
After unpacking the development system, attach an antenna to the decoder
board, install the supplied 9V battery, and turn on the power switch. The
encoder and decoder are set at the factory and will work straight out of the
box. To create a new operational setup, follow these steps:
If the boards fail to work out of the box, then try the following:
If all of these appear to be in order, then you can call 800-736-6677 or e-mail
[e-mail] for technical support.
CREATE_KEY button to enter Create Key Mode. Release the LEARN button
and press the CREATE_KEY button ten times to generate the KEY.
transmitter to activate the infrared receiver. Hold the back of the transmitter
close to the IR key exchange area on the decoder board until the MODE_IND
LED on the board lights up.
transmitter that is to be granted recognition permission.
again, or wait until the 15 second time-out occurs. The permissions will now be
saved in the decoder.
process was successful.
decoder and needs to be sent to the encoder before they will communicate.
the handheld transmitter to use a particular line, then when you press a button
on the transmitter, the MODE_IND LED on the decoder board will light up, but
the data line LED will not light up.
Page 3