PC1S3052NTZF Sharp Microelectronics, PC1S3052NTZF Datasheet - Page 8

• Manufacturer Part Number: PC1S3052NTZF
• Description: Triac & SCR Output Optocouplers DIP6 Phototriac Non ZC 600V 10mA
• Manufacturer: Sharp Microelectronics

Specifications of PC1S3052NTZF

• Configuration: 1
• Maximum Continuous Output Current: 100 mA
• Maximum Input Current: 50 mA
• Maximum Operating Temperature: + 100 C
• Maximum Reverse Diode Voltage: 6 V
• Maximum Turn-on Time: 50 us
• Minimum Operating Temperature: - 30 C
• Output Type: AC
• Package / Case: PDIP-5
• Typical Input Voltage: 1.2 V
• Zero-crossing Circuit: No
• Output Device: Triac
• Isolation Voltage: 5 kV
• Peak Output Voltage (vdrm): 600 V
• Maximum Input Voltage: 1.4 V
• Maximum Output Voltage: 420 VAC
• Minimum Trigger Current: 10 mA (Max)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

■ Design Considerations
● Design guide
● Degradation
● Recommended foot print (reference)
SMT Gullwing Lead-form
In order for the Phototriac to turn off, the triggering current (I
Please refrain from using these devices in a direct drive confi guration.
These Phototriac Coupler are intended to be used as triggering device for main Triacs.
Please ensure that the output rating of these devices will be suffi cient for triggering the main output Triac of
your choice. Failure to do may result in malfunctions.
In phase control applications or where the Phototriac Coupler is being by a pulse signal, please ensure that
the pulse width is a minimum of 1ms
For designs that will experience excessive noise or sudden changes in load voltage, please include an
appropriate snubber circuit as shown in the below circuit.
Please keep in mind that Sharp Phototriac Couplers incorporate superor dV/dt ratings which can often
eliminate the need for a snubber circuit.
In general, the emission of the IRED used in Phototriac Couplers will degrade over time.
In the case where long term operation and / or constant extreme temperature fl uctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5 years.
Therefore in order to maintain proper operation, a design implementing these Phototriac Couplers should
provide at least twice the minimum required triggering current from initial operation.
2.2
8.2
(Unit : mm)
8
F
) must be 0.1mA or less
PC1S3052NTZF Series
Sheet No.: D2-A08801EN